Whirlpool AK 141, KDU 1476, ARC 0640, CP101 MI, ART 415/H Instructions Manual
...
ENVlROhlMENTAL
Packing
Do
ferent materials (i.e.: steel, cardboard, polystyrene) following local
regulations.
Declaration of conformity
This appliance is inteded to come into contact with foodstuffs
and conforms to D.L. 108 of 25.01.1992 (European Directive
89/109/EEC).
Information
This appliance is free of
free of HK's (refrigerant circuit contains R600a
For more details, please refer to the rating plate on the appliance.
For appliances with lsobutane (R600a)
The refrigerant lsobutane is a natural gas of high environmental
compatibility but which
to ensure that the ducts of the refrigerant circuit do not get damaged.
VJlQW
The appliance you have just bought allows, dependent on models, the storage of fresh foods and if
temperature compartment marked by a symbol
zing-in of small quantities of foods, the storage of commercially
frozen foods and the production of ice cubes.
The appliance fitted with super insulation have been designed to
grant high performances with a reduced energy consumption.
Please read these instructions carefully, you will find the description of your appliance and the useful hints to obtain the best
performance to store foods.
n4
LJ
not throw the packing into the garbage: first sort out the dif-
VOUR
ESC9lpTlO"u
1) Temperature control knob of both compartments (thermostat)
2) Light switch
3) Low temperature compartment
4) Grids (adjustable in height)
5) Separator
6)
Crispers
7)
Inner door liner with racks
8)
Butter and eggs compartment
HINTS
CK'S
(refrigerant circuit contains R134a) or
si
inflammable. Therefore,
APPLIANCE
it
is equipped with the low
OF
THE
AppLlANCE
-
kobutane).
it
is essential
-,
(Fig.
the free-
I)
FVSTALbATlON
Please ensure that the appliance is undamaged. Transit dam-ages
must be reported to your delaer within 24 h of receipt of the ap-
pliance. We suggest you wait 1 hour approx, before connecting
the appliance to the mains to allow the refrigerant circuit to be
effective. The appliance should not be installed close to heat
sources, central heating, cookers, boilers, sunlight, etc.
however be located in a well ventilated dry space.
If
the appliance is installed under a kitchen furniture, leave a
50mm air gap
required, the front foot
Fit the spacers (if provided) on the top of the condenser
To ensure free air circulation, ensure that the ventilation grid
tuated above the appliance
Clean the interior with a sponge dampened in a solution of warm
water and bicarbonate of soda or vinegar.
IY\lSTACLATIBN
A
!Ajo
This appliance can be installed under a worktop, situated at a distance of 850 mm from the floor. Proceed as follows:
-
Remove screws 9 and
worktop of the appliance
-
Cut a ventilation opening in the worktop
-
Install the appliance under the worktop and fix it at the front by
means of the screws
the appliance.
-
Mantain the distance from the rear wall as shown
8:
YTQ
(Fig.
g
2).
Ensure that the appliance
(Fig.
3).
is
not obstructed
OF
THE
APPLIANCE
10
(at the front and rear) and remove the
(Fig. 16).
1
O
previously removed from the worktop of
is
(Fig.
(Fig. 17).
It
must
level; adjust, if
(Fig.
5).
UhlDER
(Fig. 17).
4).
si-
ELECTRICAL CONNECTION AND OPERATION
Check that the voltage on the rating plate, situated at the right
hand side of the crisper corresponds to the voltage in your home
(Fig. 6).
The earthing of this appliance
manufacturer will accept no liability for injury to persons
or damage to objects arising from the non-observance of
this requirement.
If the plug and the wall socket do not comply, have the socket replaced by a qualified electrician.
He should also check that the section of the socket wires can
withstand the power absorbed by the appliance. The use of adapters, multiple sockets and extension cords is not advisable.
If
absolutely necessary, use simple or multiple adapters and extenson cords in compliance with local safety regulations, paying attention not to exceed the maximum amperage, which is marked
on the simple adaptors and on extension cords and that of the
total power marked on the multiple adapters. With the appliance
plugged in, the interior light should come on when the refrigerator door is opened, unless the thermostat control knob is set to
symbol.
Adjust the thermostat control knob as suggested in the next
chapter. The refrigerator is ready for use.
For Great Britain only:
is
compulsory by law. The
O
ELECTRICAL INFORMATION
WARNING -THIS APPLIANCE MUST
Fuse replacement
If the mains lead of this appliance is fitted with a
amp fused plug, to change a fuse in this type of plug use an
A.S.T.A. approved fuse to
Correct replacements are identified by the colour insert or the
colour embossed in words on the base of the plug.
Replacement fuse covers are available from your local electrical
store.
CONNECTION
If
the fitted plug is not suitable for your socket outlet, then it
should be cut off and disposed of in order to avoid a possible
shock hazard should it be inserted into a 13A socket elsewhere.
A suitable alternative plug should then be fitted to the cable. The
wires in this mains lead are coloured in accordance with the fol-
lowing code:
BLUE "NEUTRAL" ("N")
BROWN "LIVE" ("L")
GREEN AND YELLOW "EARTH" ("E)
1. The GREEN AND YELLOW wire must be connected to the terminal in the plrg which is marked with the letter
Earth symbol = or coloured green or green and yellow.
2. The BLUE wire must be connected to the terminal which is
marked with the letter "N" or coloured black.
3. The BROWN wire must be connected to the terminal which
marked with the letter
BS
1362 type and proceed as follows:
1.
fuse (B)
2. Fit replacement 13A fuse into fuse cover
3. Refit both into plug.
IMPORTANT
be refitted when changing a fuse
and if the fuse cover is lost the plug
must not be used until a correct re-
placement is fitted.
TO
A REWIREABLE PLUG
"L"
or coloured red.
BE
EARTHED
BS
1363A 13
Remove the fuse cover
The fuse cover must
"E"
(A)
and
or by the
is
Loading...