Whirlpool AKZ 350 IX, AKZ 360 IX User Manual
3gb66002a.fm5 Page 4 Wednesday, April 3, 2002 2:32 PM
INSTRUCTION FOR USE
INSTALLATION
ELECTRICAL CONNECTION
BEFORE USING THE OVEN
HINTS FOR PROTECTING THE ENVIRONMENT
PRECAUTIONS AND GENERAL SUGGESTIONS
OVEN ACCESSORIES
CLEANING THE OVEN AND ITS ACCESSORIES
TROUBLESHOOTING GUIDE
AFTER SALES SERVICE
DECLARATION OF CONFORMITY CE
4
3gb66002a.fm5 Page 5 Wednesday, April 3, 2002 2:32 PM
INSTALLATION
Technical information for the installer
Unpack the oven to make the connections.
Rest the oven on the polystyrene base to avoid damaging it.
Do not lift the oven by the door handle, but hold it at the sides.
Make sure that the appliance has not been damaged during transport.
The dimensions of the oven and the unit are given in the picture below.
Units in contact with the oven must be heat resistant (90°C).
If plastic laminates or the sealing material are not sufficiently heat resistant, bubbles may
form, the surface may be deformed or the coating may detach.
House the oven in the unit cavity, lifting it at the sides and making sure that the supply
cable is not trapped.
To ensure correct ventilation, respect the ventilation openings indicated in the picture
(200 mm
Fasten the oven to the unit with the screws (A) as shown.
The oven can also be fitted under a cooktop.
2
minimum).
A
A
A
A
There must be a gap of at least 5 mm between the upper edge of the oven and the lower
edge of the working surface. This gap must never be closed by strips or unit reinforcing
pieces. When the oven is installed, make sure that the sides do not touch the front edges
of the unit or the adjacent drawers and door (see below picture).
No Contacts
5
3gb66002a.fm5 Page 6 Wednesday, April 3, 2002 2:32 PM
ELECTRICAL CONNECTION
Warning: Do not connect to the power supply before
you have finished connecting the oven.
Make sure the oven is installed and connected to the
electricity supply by a qualified technician in
accordance with the manufacturers instructions and
in compliance with local regulations.
The installer is responsible for the correct electrical
connection of the oven and the observance of the
relative safety regulations.
The oven must be connected to the electricity supply
by means of an all-pole disconnect switch with
minimum contact gap of 3 mm.
The oven must be grounded.
Do not use multiple plug adapters or extension leads.
After the oven has been installed, the electrical
components must be inaccessible.
Make sure that the voltage shown on the rating plate
is the same as the power supply voltage in your home.
The rating plate is on the front edge of the oven cavity
(visible with oven door open).
BEFORE USING THE OVEN
For best use of the oven please read the
instructions for use carefully and keep them
in a safe place.
Remove the cardboard protection and the
protective plastic film.
Take the accessories out of the oven and
heat it to 200°C for about an hour to remove
the smells and fumes of insulating material
and protective greases. Keep the window
open during this operation.
HINTS FOR PROTECTING THE ENVIRONMENT
1. Packing
The packaging material is 100% recyclable
and it is marked with the recycle symbol
().
2. Electrical appliances
The electrical appliances are manufactured
with recyclable or reusable material.
Dispose of them following the local
regulations for the disposal of waste. Before
disposing of them make them unusable by
cutting off the supply cable.
6
Loading...