Whirlpool AKZ 131 NB INSTRUCTION FOR USE
3gb53541.fm5 Page 13 Monday, June 3, 2002 4:55 PM
INSTRUCTIONS FOR USE
INSTALLATION
ELECTRICAL CONNECTION
BEFORE USING THE OVEN
PROTECTING THE ENVIRONMENT
PRECAUTIONS AND GENERAL RECOMMENDATIONS
OVEN ACCESSORIES
OVEN FUNCTIONS
CLEANING THE OVEN AND ACCESSORIES
TROUBLESHOOTING GUIDE
AFTER SALES SERVICE
DECLARATION OF CONFORMITY CE
13
3gb53541.fm5 Page 14 Monday, June 3, 2002 4:55 PM
INSTALLATION
Technical information for the installer
After removing the oven from its packaging, before making
the connections place it on the polystyrene foam base to
protect it from damage.
Do not attempt to lift the oven by the handle. Lift at the
sides as shown in the figure (see arrow).
Check that the appliance has not been damaged in transit.
Oven dimensions and kitchen unit dimensions are shown in
the figure opposite.
Kitchen units in contact with the oven must be heat
resistant (80° C min).
If plastic laminates or cement are not sufficiently heatresistant, warping, bubbling or detachment of the finish
may result.
Install the oven in the housing, lifting it at the sides, taking
care not to trap the wires of the electrical supply cable.
For correct ventilation, follow the ventilation opening
directions shown in the figure (500 min x 80 mm and 500
min x 50 mm inside the cabinet).
Secure the oven to the kitchen unit with screws
shown.
The oven has also been designed for building-in under a
cooktop.
NOTE
: To allow for proper ventilation, we recommend that you
leave an opening of at least 500 x 80 mm or an equivalent area
in the lower section of the housing.
(A)
as
An additional opening of 5 mm is required between the oven
top rim and the cooktop lower rim: this opening must not be
closed by strips or housing crosspieces.
During oven installation, care must be taken to ensure that the
sides are not touching the front edges of the housing or
adjacent drawers and doors (see picture).
14
No contacts
3gb53541.fm5 Page 15 Monday, June 3, 2002 4:55 PM
ELECTRICAL CONNECTION
Important: do not connect to the power supply before
you have finished connecting the oven and cooktop.
Make sure the appliance is installed and connected to the
electricity supply by a qualified technician in accordance
with the manufacturers instructions and in compliance
with local regulations.
The installer is responsible for the correct electrical
connection of the appliances and the observance of the
relative safety recommendations.
The appliance must be connected to the electricity
supply by means of an all-pole disconnect switch with
minimum contact gap of 3 mm.
The appliances must be earthed by law.
Do not use multiple plug adapters or extension leads.
After the oven has been installed, the electrical
components must be concealed.
Make sure that the voltage shown on the rating plate is
the same as the power supply voltage in your home. The
rating plate is on the front edge of the oven cavity
(visible with oven door open).
15
Loading...