Whirlpool AKZ 119/01 NB, AKZ 135 NB, AKZ 119/01 IX, AKZ 144 MR INSTRUCTION FOR USE

53111Cgb.fm5 Page 11 Monday, February 28, 2000 3:56 PM

CONTENTS GB

INSTALLATION

ELECTRICAL CONNECTION

BEFORE USING THE OVEN

PROTECTING THE ENVIRONMENT

PRECAUTIONS AND GENERAL RECOMMENDATIONS

OVEN ACCESSORIES

OVEN FUNCTIONS

CLEANING THE OVEN AND ITS ACCESSORIES

TROUBLESHOOTING GUIDE

PAGE

AFTER-SALES SERVICE

DECLARATION OF CONFORMITY CE

PAGE

53111Cgb.fm5 Page 12 Monday, February 28, 2000 3:56 PM

INSTALLATION

Technical information for the installer

•

After removing the oven from its packaging, before making the connections place it on the polystyrene foam base to protect it from damage.

•

Do not attempt to lift the oven by the handle. Lift at the sides as shown in the figure (see arrow).

•

Check that the appliance has not been damaged in transit.

•

Oven dimensions and kitchen unit dimensions are shown in the figure opposite.

•

Kitchen units in contact with the oven must be heat resistant (80°C min).

•

If plastic laminates or cement are not sufficiently heat-resistant, warping, bubbling or detachment of the finish may result.

•

Install the oven in the housing, lifting it at the sides, taking care not to trap the wires of the electrical supply cable.

•

For correct ventilation, follow the ventilation opening directions shown in the figure (500 min x 80 mm and 500 min x 50 mm inside the cabinet).

•

Secure the oven to the kitchen unit with screws (A) as shown.

•

The oven has also been designed for building-in under a cooktop.

NOTE:

To allow for proper ventilation, we recommend that you leave an opening of at least 500 x 80 mm or an equivalent area in the lower section of the housing.

An additional opening of 5 mm is required between the oven top rim and the cooktop lower rim: this opening must not be closed by strips or housing crosspieces. During oven installation, care must be taken to ensure that the sides are not touching the front edges of the housing or adjacent drawers and doors (see picture).

No contacts

53111Cgb.fm5 Page 13 Monday, February 28, 2000 3:56 PM

ELECTRICAL CONNECTION

• Important: do not connect to the power

supply before you have finished connecting the oven and cooktop.

• Make sure the appliance is installed and

connected to the electricity supply by a qualified technician in accordance with the manufacturer’s instructions and in compliance with local regulations.

• The installer is responsible for the correct

electrical connection of the appliances and the observance of the relative safety recommendations.

• The appliance must be connected to the

electricity supply by means of an all-pole disconnect switch with minimum contact gap of 3 mm.

• The appliances must be earthed by law.

• Do not use multiple plug adapters or

extension leads.

• After the oven has been installed, the

electrical components must be concealed.

• Make sure that the voltage shown on the

rating plate is the same as the power supply voltage in your home. The rating plate is on the front edge of the oven cavity (visible with oven door open).

+ 5 hidden pages