WHIRLPOOL AKT700IXL User Manual
GAS HOB
Manual of Use, Care and
Installation
Index .......................................2
IMPORTANT: We suggest that you carefully read the
instructions in this manual before using your grill.
For residential use only.
Keep this manual for the use of the electrical inspector.
Installer: Leave this manual with the owner.
Owner: Keep this manual for future
references
for the following models
400011433785
AKT700/IXL
AKT790/IXL
AKT950/IXL
INDEX
DANGER
WARNING
SECURITY..…………….....…………….....…….……… 2
INSTALLATION .….....................……….............….…… 4
Technical information for the installer..............……… 4
Product dimensions and spaces of
Installation ………………............................…………… 4
Assembly ..………………………….………….… 5
Gas Connection.........…....…………….…....…...…….....5
Adjustments for dierent types of Gas .……............… 6
Minimum adjustment of the Gas level in Valves….….6
Replacing the Injectors...................................…………….6
Injector table for model .........................................……….7
ELECTRICAL CHARACTERISTICS..........…………....…… 7
Nominal Electrical Characteristics…….....…………… 7
Electrical Diagrams...…………….....….….…………… 8
PARTS AND FEATURES...................................…........….9
HOW TO USE OF THE HOB..……….....………………......11
Burner ignition............................………………………. 11
Practical advice for the use of
Burners...............….........………………........................…..11
MAINTENANCE AND CLEANING…….……….…….…...12
Cleaning the hob surface..........................................….....12
Cleaning the hob parts.............................................…......12
TROUBLESHOOTING…...........…..…………………….. 12
WARRANTY…..………………………….…….…........… 13
PRODUCT SAFETY
Your safety and safety of others are very important.
We have provided many important safety messages in this manual and your appliance.
Always read and obey all safety messages.
This is the safety alert symbol
This symbol alerts you to potential hazards that can kill or hurt you and others.
All safety messages will follow the safety alert symbol and either the word “DANGER” or “WARNING”.
This words mean:
You can be killed or seriously injured if you don’t
All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you
what can happen if the instructions are not followed.
You can be killed or seriously injured if you don’t
immediately follow instructions.
follow instructions.
IMPORTANT SAFETY INSTRUCTIONS
WARNING: To reduce the risk of re, electrocution, injury to persons or damage when using the gas grill, follow basic
precautions, including the following:
• NOTICE: Do not store items of interest to children in cupboards that are on top of a gas hob or on the back of it;
If they are not left on the hob so as not to invite the children to climb to reach an object, the children could be
seriously injured.
• This gas hob is equipped with a three-prong grounded plug for protection against the risk of electrocution and
must be plugged directly into an outlet that is grounded. Do not cut or remove the grounding tip of the plug.
• Desconecte la energía eléctrica antes de hacer una revisión al aparato electrodoméstico.
• NEVER USE THE GAS HOB AS ROOM HEATING.
• Maintenance - Keep the gas grill area clear and free of combustible materials, gasoline and other ammable vapors
and liquids.
• The size of the ames of the upper burners should be adjusted so that it does not extend beyond the edges of the
utensil.
• Keep the package of materials (plastic bags, polystyrene parts, etc.) out of the reach of children, as they are
potentially dangerous.
• Ensure that the installation of gas and electricity supplies are carried out by qualied technical personnel and in
accordance with local regulations.
• This grill must be installed and used in a well ventilated room, in accordance with current regulations. Read the
instructions carefully before installing and using this grill.
For your safety: If you smell gas:
Open the windows.
Don’t touch the
electrical
switches.
Turn o all
ames by turning o
the valve of the gas
supply line.
Contact
your gas supply
provider company
immediately.
Don’t use
For your safety:
Do not store gasoline
or other ammable liquids
close to this appliance
Make sure the furniture
close to the gas hob as well
as the wall withstand
a temperature of 95 °C,
without suering deformation.
Not following these
instructions may cause
risk of re
or explosion.
your product to warm up
the room,
it’s dangerous.
INSTALLATION
Technical Information for the installer
• This product can be embedded in a worktop 20 to 40 mm thick
• If there is no oven beneath the hob, insert a separator panel that has
a surface at least equal to the opening in the work surface. This panel,
that has to close completely the cut out in order to avoid any contact
with the bottom part of the hob, must be positioned at a maximum
distance of 150 mm below the upper surface of the work surface but,
in no case less than 20 mm from the bottom of the hob. In the case
that you intend to install an oven beneath the hob, make sure that it is
manufactured by Whirlpool and equipped with a cooling system. The
manufacturer declines all liability if another brand oven is installed
beneath the hob.
• Before installation, make sure that:
- The local gas delivery conditions (nature and pressure) are
compatible with the settings of the hob (see the rating plate and
injector table);
- The outer surfaces of the furniture or appliances adjacent to the
hob are heat resistant according to local regulations;
- The combustion gases are adequately extracted by extraction
hoods and / or extraction fans.
- That the air circulation and ventilation are adequate through an
opening in the room of at least 100 cm2. This opening should be:
a. Standing on the exterior wall;
b. it must not be obstructed at any time by any of its sides (or even
accidentally);
c. protected by plastic grilles, metal meshes, etc. taking care that the
eective ventilation area mentioned above is not reduced;
d. be located near the oor and positioned so that it doesn’t interfere
with the operation of the gas extraction system.
NOTE: If installing an extraction hood on the hob, please refer
to the hood installation instructions to check the appropriate
installation dimensions.
Model AKT790
Product Dimensions and Installation
Model AKT700
NOTE: if the distance “A” between the wall cabinets is between 600
mm and 730 mm, the height “B” must be a minimum of 530 mm.
if the distance “A” between the wall cabinets is greater than the
width of the hob, the height “B” must be a minimum of 400 mm.
In case of installation of a hood above the hob, please refer to the
hood instructions fot the correct distance.
Model AKT950
860
840
50 mm
40 mm
30 mm
A
A: Metal Hob
Top
Top
Top
B: Metal VTC
WARNING
NOTE: if the distance “A” between the wall cabinets is between 600
mm and 730 mm, the height “B” must be a minimum of 530 mm.
if the distance “A” between the wall cabinets is greater than the
width of the hob, the height “B” must be a minimum of 400 mm.
In case of installation of a hood above the hob, please refer to the
hood instructions fot the correct distance.
Assembly
After having cleaned the perimeter surface, apply the supplied gasket to
the hob as shown in the gure.
Position the hob in the worktop opening made respecting the
dimensions indicated in the Instruction.
NOTE: the power supply cable must be long enough to permit its
upward extraction.
Only for AKT950
Excessive Weight Hazard
Use two or more people to move and install product .
Failure to do so can result in back or other injuty
Gas Connection
• The gas supply system must comply with local regulations.
• You can nd specic local regulations for some countries in the
paragraph “Reference to Local Regulations”. If no information
concerning your Country is given, please ask details to your Installer.
• The connection of the hob to the gas pipe network or gas cylinder
must be made by means of a rigid copper or steel pipe with ttings
complying with local regulations, or by means of a continuous-surface
stainless steel hose complying with local regulations. Interpose gasket
(B) in the elbow connection. The maximum length of the hose is 2 m.
• Before connecting the pipe to the elbow-shaped connection (A),
insert the washer (B) supplied in accordance with EN 549.
To secure the hob, use the brackets (A) provided with it. Fit the brackets
into the relevant bores shown by the arrow and fasten them by means
of their screws in accordance with the thickness of the worktop (see the
following gures).
Loading...