Whirlpool AKT 607/WH, AKT 607/NB, AKT 607/IX PROGRAM CHART

GB
AKT 607 PRODUCT DESCRIPTION SHEET Destinations
Removable panstand grids
1.
Auxiliary burner
2.
Semi-rapid burner
3.
Semi-rapid burner
4.
Ultra-rapid burner
5.
Auxiliary burner control knob
6.
Semi-rapid burner control knob
7.
Semi-rapid burner control knob
8.
Ultra-rapid burner control knob
9.
SYMBOLS
Tap closed Maximum flame Minimum flame
LIGHTING THE BURNERS
To ignite one of the burners, turn the relative knob anti-clockwise to the maximum flame setting .
Press the knob against the control panel to ignite the burner.
The device must not be pressed for more than 15 sec. If, after that time has elapsed, the burner does not remain lit, wait at least one minute before trying to light it again.
- The burner might go out when the knob is released. This means that the thermocouple has not warmed up enough.
In this case, repeat the operations described above.
PRATICAL ADVICE FOR USING THE BURNERS
For better burner performance, please stick to the following rules:
- Use pots and pans that fit the burners (see table on the
right).
- Only use flat-bottomed pots and pans.
- Use the correct amount of water for cooking foods and
keep the pot covered.
Burner Pot Ø
ultra-rapid semi-rapid
auxiliary
from 24 to 26 cm from 16 to 22 cm
from 8 to 14 cm
FR
DIMENSIONS AND DISTANCES TO BE MAINTAINED (mm)
NOTE: In case of installation of a hood above the cooktop, please refer to the hood instructions for the correct
distance.
INJECTOR TABLE CATEGORY II2H3B/P
Type of gas used Type of burner Ø injector Rated thermal
NATURAL GAS
(Methane) G20
LIQUID PETROLEUM GAS
(Butane-Propano) G30-G31
Type of gas used
G20 20 mbar 4 burners 7.80 742 l/h 9.52
G30-G31 30 mbar 4 burners 7.80 567 g/h 30.94
ultra-rapid semi-rapid auxiliary
ultra-rapid semi-rapid auxiliary
Configuration model
flow rate kW
136
95 78
94 67 50
Rated thermal flow rate kW
3.50
1.65
1.00
3.50
1.65
1.00
Rated consumption
333 l/h 157 l/h
95 l/h
254 g/h 120 g/h
73 g/h
Total rated consumption
Reduced heat capacity kW
0.60
0.35
0.30
0.60
0.35
0.30
Gas pressure (mbar)
min. rat. max.
17 20 25
25 30 35
Air necessary (m3) for the combustion of 1 m
3
of gas
5019 319 01102
ELECTRIC SUPPLY: 230 V - 50 Hz
To get full satisfaction from the hob, please read these instructions carefully and keep them for future consultation.
PRECAUTIONS AND GENERAL ADVICE
To get full satisfaction from your hob, please read these instructions carefully and keep them for future consultation
These instructions are only valid for those Countries where the destination abbreviations are mentioned on the product description sheet and on the hob.
Keep the packaging material (plastic bags, polystyrene parts, etc.) out of the reach of children, as they are potentially dangerous.
Check whether the hob has been damaged during transport and remove any protective film from the appliance parts.
This hob (Class 3) is designed solely for household use for cooking food. Any other use (such as heating rooms) is to be considered improper and, as a consequence, dangerous.
Ensure that the installation and gas/electrical connections are performed by a qualified technician in compliance with current local safety regulations.
This appliance should only be installed and used in well-ventilated rooms, in accordance with current regulations. Carefully read the instructions before installing and using this appliance.
Gas adjustment and supply pressure are indicated on the rating plate located under the hob. If the appliance is arranged for a type of gas different from that available, refer to the paragraph “Ajustment to different types of gas”.
REFERENCE TO LOCAL REGULATIONS
FR
The installation and maintenance of the appliance must be carried out by a qualified skilled technician in accordance with the regulations in force, and in particular:
- Decree of 2 August 1977
Technical and Safety Rules applicable to fuel gas and liquefied hydrocarbon installations located within residential buildings and outbuildings.
- Standard DTU P 45 - 204
Gas installations (formerly DTU no. 61-1 - Gas installations April 1982 + supplement no. 1 of July 1984).
- Departmental Health Regulations
For appliances connected to the mains electricity supply.
- Standard NF C 15-100
Low-voltage electrical installations - Standards.
PROTECTING THE ENVIRONMENT
1.
Packaging
The packaging material is entirely recyclable, and is marked with the recycling symbol , which identifies it as a type of material that must be sent to local waste-disposal centres.
2.
Product
This appliance is marked according to the European directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE). By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product.
The symbol on the product, or on the documents accompanying the product, indicates that this appliance may not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of
electrical and electronic equipment. Disposal must be carried out in accordance with local environmental regulations for waste disposal. For more detailed information about treatment, recovery and recycling of this product, please contact your local city
office, your household waste disposal service or the shop where you purchased the product.
Declaration of conformity
This hob has been designed, constructed and marketed in compliance with:
- safety requirements of EEC Directive “Gas” 90/396
- safety objectives of the “Low Voltage” Directive 2006/95/CE (which replaces 73/23/CEE and subsequent amendments)
- protection requirements of EEC Directive “EMC” 2004/108
- requirements of EEC Directive 93/68
This cooktop is suitable for contact with foodstuffs and complies with EEC (CE) Regulation n. 1935/2004.
:
NOTES
Improper use of the grids can result in damage to the hob surface. Do not position the grids upside down or drag them across the hob.
If the hob has a glass ceramic top, do not use:
- Cast iron griddles or terracotta pots and pans
- Heat diffusers (e.g. metallic mesh)
- Two cookers for the same pot
In case of prolonged use, additional ventilation may be needed (opening a window or increasing the extraction force of the hood).
This appliance is not intended for use by persons (including children) wit reduced physical, sensory or mental capabilities or lack of experiences and knowledge unless they have been given initial supervision or instruction concerning use of the appliance by a person responsible for their safety.
Keep children away from the hob when it is in use and do not let them play with the controls or any other appliance parts.
Warning
grids, please ensure that all the feet are correctly fitted.
Attention
After use, make sure that the knobs are in position OFF and close the main gas delivery or cylinder tap
INSTALLATION
: the protective rubber feet on the grids represent a chocking hazard for young children. After removing the
: the glass lid (if provided) may shatter if overheated. Before closing it, make sure that all the burners are off.
TECHNICAL INFORMATION FOR THE INSTALLER
This product can be embedded in a worktop 20 to 40 mm thick.
If there is no oven beneath the hob, insert a separator panel that has a surface at least equal to the opening
in the work surface. This panel must be positioned at a maximum distance of 150 mm below the upper surface of the work surface but, in no case less than 20 mm from the bottom of the hob. In the case that you intend to install an oven beneath the hob, make sure that it is manufactured by Whirlpool and equipped with a cooling system. The manufacturer declines all liability if another brand oven is installed beneath the hob.
Before installation, make sure that:
- the local gas delivery conditions (nature and pressure) are compatible with the settings of the hob (see the
rating plate and injector table).
- The outer surfaces of the furniture or appliances adjacent to the hob are heat resistant according to local regulations.
- Combustion products are discharged outdoors through specific hoods or wall and/or window mounted electrical fans.
2
- Continuous natural air circulation is ensured through a clear opening in a wall of at least 100 cm
be: a) permanent and in a wall to the outside of the room to be vented; b) made in such a way that it cannot be obstructed from the inside or outside (not even accidentally); c) protected by plastic grids, metallic mesh, etc., taking care not to reduce the air vent effective area mentioned above; d) located near floor level and positioned so as not to interfere with the operation of the exhaust system.
. This wall opening must
Loading...