Whirlpool AKR 811 WH, AKR 506 IX, AKR 811 MR IMPORTANT SAFETY INSTRUCTIONS

GB8
IMPORTANT SAFETY INSTRUCTIONS
YOUR SAFETY AND THAT OF OTHERS IS PARAMOUNT
This manual and the appliance itself provide important safety warnings, to be read and observed at all times.
This is the attention symbol, pertaining to safety, which alerts users to potential risks to themselves and others.
All safety warnings are preceded by the attention symbol and the following terms:
indicates a hazardous situation which, if not avoided, will cause serious injury.
Indicates a hazardous situation which, if not avoided, could cause serious injury.
Installation and maintenance must be carried out by a qualified technician, in compliance with the manufacturer's instructions and local safety regulations. Do not repair or replace any part of the appliance unless specifically stated in the user manual.
The appliance must be disconnected from the power supply before carrying out any installation work.
Earthing of the appliance is compulsory. (Not possible for class II hoods identified by the symbol on the dataplate).
The power cable must be long enough for connecting the appliance, once fitted in its housing, to the power supply socket.
Do not pull the power supply cable in order to unplug the appliance.
The electrical components must not be accessible to the user after installation.
Do not touch the appliance with any wet part of the body and do not operate it when barefoot.
The appliance is not intended for use by persons (including children) with any physical, sensory or mental impairment, or without experience and knowledge of the appliance, unless supervised or previously instructed in its use by those responsible for their safety.
Do not repair or replace any part of the appliance unless specifically indicated in the manual. All other maintenance services must be carried out by a specialised technician.
Children must be supervised to ensure they do not play with the appliance.
When drilling through the wall pay attention not to damage electric connections and/or pipes:
Air vents must always discharge to the outside.
The manufacturer rejects all responsibilities for any damage caused by improper use or wrong settings.
Appropriate maintenance and cleaning ensure the good working order and the best performance of the appliance. Regularly clean all stubborn surface dirt to avoid grease build up. Remove and clean or change the filter regularly.
Never flame cook food (flambé) under the appliance. Using free flames might cause fire.
Failure to observe the instructions for cleaning the hood and replacing the filters may result in a fire.
Exhaust air must not be vented through a flue used for removal of fumes produced by gas combustion appliances or other combustible materials, but must have a separate outlet. All national regulations governing extraction of fumes must be observed.
If the hood is being used at the same time as other appliances using gas or other combustible materials, the negative pressure of the room must not exceed 4 Pa (4x 10-5 bars). For this reason ensure that the room is well ventilated.
Do not leave frying pans unattended when frying, as the frying oil may catch fire.
Before touching the light bulbs, ensure that they are cold.
Do not use or leave the hood without the light bulb correctly fitted, as this may cause electric shock.
The hood is not a worktop, therefore do not place any objects on top of it or overload it.
During all installation and maintenance operations wear appropriate working gloves.
This appliance is not suitable for outdoor use.
When the hob is in use, accessible parts of the hood may become hot.
Scrapping of household appliances
This appliance is manufactured with recyclable or reusable materials. Dispose of it in accordance with local waste disposal regulations. Before scrapping, cut off the power supply cable.
For further information on the treatment, recovery and recycling of household electrical appliances, contact your competent local authority, the collection service for household waste or the store where you purchased the appliance.
KEEP THIS BOOKLET FOR FUTURE CONSULTATION.
WARNING:
DANGER:
GB9
After unpacking the appliance, check for any transport damage. In the event of problems, contact the dealer or your nearest After-sales Service. To prevent any damage, only remove the appliance from its polystyrene foam packaging at the time of installation.
PREPARING FOR INSTALLATION
this is a heavy product; the hood should only be lifted and installed by two or more people.
The minimum distance between the cooking pans on top of the cooker and the bottom of the hood must not be less than 45 cm for electric cookers and 65 cm for gas or mixed cookers. Before installation also check the minimum distances stated in the manual of the cooker. If the installation instructions for the cooker specify a greater distance between cooker and hood, this distance must be observed.
ELECTRICAL CONNECTION
Make sure the power voltage specified on the appliance rating plate is the same as the mains voltage. This information may be found on the inside of the hood, under the grease filter. Power cable replacement (type H05 VV-F) must be carried out by a qualified electrician. Contact an authorized service centre. If the hood is fitted with an electric plug, connect the plug to a socket complying with current regulations, located in an accessible place. If no plug is fitted (direct wiring to the mains), or if the socket is not located in an accessible place, install a standardised double pole power switch that will enable complete isolation from the mains in case of category III overvoltage conditions, in accordance with installation rules.
GENERAL RECOMMENDATIONS Before use
Remove cardboard protection pieces, protective film and adhesive labels from accessories. Check the appliance for any transport damage.
During use
To avoid any damage do not place any weights on the appliance. Do not expose the appliance to atmospheric agents.
WARNING:
INSTALLATION
Disposal of packing
The packing material is 100% recyclable and is marked with the recycle symbol ( ). The various parts of the packing must therefore be disposed of responsibly and in full compliance with local authority regulations governing waste disposal.
Scrapping the product
- This appliance is marked in compliance with European Directive 2002/96/EC, Waste Electrical and Electronic Equipment (WEEE).
- By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product.
- The symbol on the product or on the accompanying documentation indicates that it should not be treated as domestic waste but must be taken to an appropriate collection centre for the recycling of electrical and electronic equipment.
SAFEGUARDING THE ENVIRONMENT
GB10
The appliance does not work:
Check for the presence of mains electrical power and if the appliance is connected to the electrical supply.
Turn off the appliance and restart it to see if the fault persists.
The hood's suction level is not sufficient:
Check the suction speed and adjust as necessary:
Check that the filters are clean:
Check the air vents for any obstructions.
The light does not work;
Check the light bulb and replace if necessary;
Check that the light bulb has been correctly fitted.
Before calling the After-Sales Service:
1. See if you can solve the problem yourself with the help of the suggestions given in the "Troubleshooting guide".
2. Switch the appliance off and back on again it to see if the fault persists.
If after the above checks the fault still occurs, get in touch with the nearest After-sales Service. Always specify:
a brief description of the fault;
the exact type and model of the appliance;
the service number (number after the word Service on the rating plate), located on the inside of the appliance. The service number is also indicated on the guarantee booklet;
your full address;
your telephone number.
If any repairs are required, please contact an authorised After-sales Service (to guarantee that original spare parts will be used and repairs carried out correctly).
- Never use steam cleaning equipment.
- Disconnect the appliance from the power supply.
IMPORTANT: do not use corrosive or abrasive detergents. If any of these products accidentally comes into contact with the appliance, clean immediately with a damp cloth.
Clean the surfaces with a damp cloth. If it is very dirty, add a few drops of washing up detergent to the water. Finish off with a dry cloth.
IMPORTANT: do not use abrasive sponges or metallic scrapers or scourers. Over time, these can ruin the enamel surface.
Use detergents specifically designed for cleaning the appliance and follow the manufacturer instructions.
IMPORTANT: In order to avoid product damages, do not spray cleaners directly to the control while cleaning the Hood.
IMPORTANT: clean the filters at least monthly to remove any oil or grease residuals.
WARNING
TROUBLESHOOTING GUIDE
AFTER-SALES SERVICE
CLEANING
Loading...
+ 4 hidden pages