Whirlpool AKL 806 INSTRUCTION FOR USE

GB TABLE OF CONTENTS

INSTALLATION

ELECTRICAL CONNECTIONS

BEFORE USING THE APPLIANCES

PROTECTING THE ENVIRONMENT

PRECAUTIONS AND GENERAL RECOMMENDATIONS

OVEN ACCESSORIES

CONTROL PANEL

OVEN FUNCTIONS TABLE

USING THE COOKTOP CONNECTED

PAGE

TO THE OVEN

CLEANING THE OVEN AND ACCESSORIES

AFTER SALES SERVICE

DECLARATION OF CONFORMITY CE

PAGE

INSTALLATION

Technical information for the installer OVEN

•

After removing the oven from its packaging, before making the connections place it on the polystyrene foam base to protect it from damage.

•

Do not attempt to lift the oven by the handle. Lift at the sides as shown in the figure (see Arrow).

•

Check that the appliance has not been damaged in transit.

•

Oven dimensions and kitchen unit dimensions are shown in the opposite figure.

•

Kitchen units in contact with the oven must be heat resistant (80° C).

•

If plastic laminates or cement are not sufficiently heat-resistant, warping, bubbling or detachment of the finish may result.

•

Connect the earth wire (A) of the cooktop to the oven (B)as illustrated.

•

Connect clamps (C) of the cooktop to the oven junction block (D) situated in the upper section, following the colour code indicated on the plate.

•

For correct ventilation, follow the ventilation opening directions shown in the figure (at least 500 x 80 mm). Also provide for at least 5 mm clearance between the top of the oven and the lower edge of the worktop. This space must not be obstructed by cross rails or other structural elements.

•

During oven installation, care must be taken to ensure that the sides are not touching the front edges of the housing or adjacent drawers and doors (see picture).

•

Carry out the electrical connections between cooktop and oven (see chapterElectrical Connections”).

•

Secure the oven to the kitchen unit with screws (A) as shown.

No contacts

ELECTRICAL CONNECTIONS

• Make sure the appliances are installed and connected to the electricity supply by a qualified technician in accordance with the manufacturer’s instructions and in compliance with local regulations.

• The installer is responsible for the correct electrical connection of the appliances and the observance of the relative safety prescriptions.

• The oven must be connected to the electricity supply by means of an all-pole disconnect switch with minimum contact gap of 3 mm.

Connecting the oven to the power supply

Make sure that the voltage shown on the rating

•

plate is the same as the power supply voltage in your home. The rating plate is on the front edge of the oven cavity (visible with oven door open). Use a type H05RR-F power cord (minimum

•

length 800 mm).

• Attention: All the oven’s components operate at 230-240 V. When using a 400 V connection, make sure that the voltage reaching the oven is 230-240 V, as illustrated in the side table.

• The appliances must be earthed by law.

• Do not use multiple plug adapters or extension leads.

• After the oven has been installed, the electrical components must be inaccessible.

Conductors X

number

1N + 2N + 3+ 3N +

Connection

~ ~

H05 RR-F 3x4 mm² H05 RR-F 4x2,5 mm² H05 RR-F 4x2,5 mm² H05 RR-F 5x1,5 mm²

+ 6 hidden pages