Whirlpool ADP 923/2 WH, ADG 931/2 NB, ADG 931/2 IN, ADG 931/2 AV, ADG 954/2 User Manual
...
GB SUMMARY
BEFORE USING THE DISHWASHER
PROTECTING THE ENVIRONMENT
PRECAUTIONS AND GENERAL RECOMMENDATIONS
ENERGY AND WATER SAVING TIPS
HOW TO FILL THE SALT CONTAINER
HOW TO FILL THE RINSE AID DISPENSER
HOW TO FILL THE DETERGENT DISPENSER
CONNECTIONS
MAINTENANCE AND CLEANING
PAGE
PAGE
PAGE
PAGE
PAGE
PAGE
PAGE
PAGE
PAGE
11
11
11
11
12
13
13
14
16
TROUBLESHOOTING GUIDE
AFTER-SALES SERVICE
For maximum satisfaction from your dishwasher, carefully read these user
instructions and consult the wash programme chart.
PAGE
PAGE
17
17
10
BEFORE USING THE DISHWASHER
After unpacking, make sure the appliance is
•
undamaged and that the door closes
correctly. Do not use the appliance if it is
damaged. If in doubt, consult your local
retailer.
Keep potentially hazardous packaging
•
(plastic bags etc.) out of the reach of children.
PROTECTING THE ENVIRONMENT
1. Packing
The packing box may be fully recycled as
confirmed by the recycling symbol .
PRECAUTIONS AND GENERAL RECOMMENDATIONS
Child safety
Do not allow children to play with the
•
dishwasher.
Store the detergent, rinse aid and salt in a dry
•
place out of the reach of children.
General recommendations
Only use detergents, rinse aids and
•
regeneration salts specially recommended
for use in domestic dishwashers.
On completion of the wash programme
•
switch off the dishwasher and turn off the
water tap.
Before cleaning or carrying out maintenance,
•
switch off the appliance, disconnect the
mains plug and turn off the water tap.
If a fault occurs, switch off the appliance and
•
turn off the water tap.
The open dishwasher door can only support
•
the weight of the loaded rack when pull out.
Do not rest objects on the open door or sit or
stand on it since the appliance may topple
over.
This appliance is designed for use in the
•
home in compliance with its intended
purpose.
All water and electrical connections must be
•
carried out by a qualified technician in
compliance with the manufacturer's
instructions (refer to the enclosed installation
booklet) and current local safety regulations.
2. Appliance
The appliance is built from reusable
materials.
If you decide to scrap the dishwasher, it
must be disposed of in compliance with local
waste disposal laws. Before scrapping, cut
off the power cable so that the appliance
cannot be connected to the mains.
If necessary, the power cable may be
•
replaced with one the same obtained from
our After-Sales Service. The power cable
must only be replaced by a qualified
technician.
• For appliances with water-stop system:
The water inlet hose and plastic casing
contain electrical components. Do not
therefore cut the hose or immerse the plastic
casing in water. If the hose is damaged
switch off the appliance immediately.
Do not use solvents inside the dishwasher:
•
risk of explosion!
Load capacity: 9 place settings
•
.
EC Declaration of Conformity
This appliance has been designed,
constructed and distributed in compliance
with the safety requirements of EC
Directives:
73/23/EC
•
89/336/EC
•
93/68/EC
•
ENERGY AND WATER SAVING TIPS
Do not rinse crockery under running water.
•
If ecological energy sources are available
•
such as solar panel heating, heat pumps or
centralised heating systems, the appliance
may be connected to the hot water mains up
to a maximum temperature of 60°C.
Make sure the water inlet hose is of the
correct type. Refer to the “Connections”
chapter in these user instructions.
11
HOW TO FILL THE SALT CONTAINER
Check the water hardness level in your
area.
Consult your local Water Board, check your
last water bill for the correct adjustment.
• Set the water hardness by turning the
selector (if fitted and according to the
model).
Use the tables below to set the dial
to the required setting:
•
with 5 settings (see drawing):
Selector
setting
1 1 soft * 0 - 15 0 - 9
1 1 - 2 medium 16 - 25 10 - 15
2 2 medium 26 - 38 16 - 22
3 3 medium-hard 39 - 60 23 - 35
4 4 hard 61 - 80 36 - 46
5 4 very hard 81 - 92 47 - 54
If the water hardness level falls within category
*
(soft), no salt is required.
•
with 3 settings (see drawing):
Minimum adjustment 0 - 15 0 - 9
Medium adjustment 16 - 40 10 - 23
Maximum adjustment 40 - 92 24 - 54
Water
hardness
Water
hardness
French
degrees °fH
French
degrees °fH
German
degrees °dH
German
degrees °dH
• If the water hardness level exceeds
category 1-2 (medium), before using the
dishwasher for the first time, fill the salt
container and run a wash cycle so that
any excess saline solution discharged is
immediately removed by the water to
prevent corrosion. The pre-rinse cycle is
not sufficient for this purpose.
• Check the salt level regularly.
• Important: Only use regeneration salts
recommended for use in domestic
dishwashers. Do not fill the salt container
with detergent as this will cause
irreparable damage to the water softener
system.
To fill the salt container:
1.
Remove the lower rack.
2.
Unscrew the cap by turning it counterclockwise.
3.
If the dishwasher is new, fill the salt container
with water (about 1 liter).
4.
Fill the container by using the provided funnel
to the rim with salt (about 1.2 kg) and stir.
5.
Screw the cap back on by turning it
clockwise.
5 Settings: (Factory setting 2).
3 Settings: (Factory setting Max.).
Salt level indicator
The dishwasher is equipped with an electric salt
level indicator (depending on the model).
Electric indicator:
The salt level indicator lamp on the control
panel illuminates when the salt container is
empty.
12
Loading...