Whirlpool ADP 905 WHM INSTRUCTION FOR USE

GB
ADP 905
PROGRAMME CHART
Half Load button / Multizone
Load the upper or lower rack only. This function can be used with any programme.
Press once = upper rack Press twice = lower rack Press 3 times = Off (half load function deactivated).
Programme Symbol and
temperature
Pre-rinse
Rapid 40° C
Eco 50° C
Universal 65° C
Normal 65° C
2)
1)
Crockery to be washed later. Lightly soiled crockery with no dried-on food. Normally soiled crockery, with dried-on food. Normally soiled crockery. Normally or heavily soiled crockery.
Crockery and cutlery
Load
Detergent
Pre-rinse
(small
compartment)
- - 8.0 0.02 12 7.2 0.02 12
- + 15.0 0.85 31 13.0 0.75 30
+ + 19.0 1.40 87 17.0 1.30 85
- + 15.0 1.43 81 13.0 1.40 79
+ + 19.0 1.60 87 17.0 1.47 85
Washing
(large
compartment)
Start button indicator lamp
Switches on when the dishwasher is operating. Flashes when a fault occurs. Switches off at the end of the programme.
Consumption *
Normal load
Water (Liter)
Energy
(kWh)
Time
(Min.)
Consumption *
Half load
Water
Energy
(Liter)
(kWh)
Time
(Min.)
1) Programme recommended when using detergents of type A (non enzyme-based detergents).
2) Programme recommended when using detergents of type B (enzyme-based detergents).
Check the programme on theenergy data plate.
(We reserve the right to make technical modifications)
5019 100 91182
Quick Reference Guide
GB
Daily check list
1. Arrange crockery so that items do not touch each other.
2. Load cups at an inclination to facilitate water circulation.
3. In general, place the cutlery in the basket with the handles positioned downwards, but ensure that sharp knives and forks that might cause injury are placed in the basket with the handles positioned upwards.
4. Make sure the water je t can reach all loaded items and that the spray arms turn freely.
5. Turn on the water supply tap before starting the dishwasher.
Important:
Switch off the dishwasher once the Start indicator lamp has
switched off. If the dishwasher is turned off during the washing programme, it will start again from the same point in the programme when it is turned back on.
If a fault occurs or you wish to change the current programme, press the “START” button fo r about 5 seconds until the Start indicator lamp switches off! Refer to the Troubleshooting Guide in these user instructions to remedy any problems.
If a regeneration salt is to be added, IMMEDIATELY
start a washing programme, in order to eliminate any residual salt.
Sometimes even when the regeneration salt container is full, the corresponding indicator lamp may illuminate during the first wash cycle.
Crockery holder:
• Down: cups and long-stemmed glasses.
• Up: plates..
Upper rack
Lower rack
Cutlery basket:
The cutlery basket can be removed to increase available space.
Loading...