Whirlpool ADP 8955 IXM INSTRUCTION FOR USE

ADP 8955

SENSE Optimum wash results coupled with maximum energy savings.

Quick Reference Guide

The two sensor-controlled programmes are recommended for routine washes.

They use double sensor technology designed to ensure optimum wash results with minimum water and energy consumption.

Further indications are given in the pages to follow and in the user instructions.

Programme selector

Start button

Indicator lamp lit while the dishwasher is operating. Flashes when a fault occurs. Switches off at the end of the programme.

Half Load / Multizone button

Load the upper or lower rack This function can be used with any programme. press once = upper rack (the indicator lamp comes on) press twice = lower rack (the indicator lamp comes on) press 3 times = Off (half load function deactivated).

Programme Symbol

and Temperature

Pre-wash

Options

only

Programme selection and

recommended load type

Recommended programme little or no dried-on food.

Recommended programme on food. Especially suitable for pans and saucepans.

Crockery to be washed later.

for routine washes

for heavily soiled crockery

Delayed start button

The wash cycle can be programmed to start after 3-6-9 hours. Then press the Start button. The wash programme will start at the set time.

, for crockery with

, with dried-

Options

Place the detergent in the:

small

compartment

X X

compartment

- - 5.0 (4.2) 0.02 (0.02) 9(9)

large

Rinse aid level indicator

Add rinse aid.

Salt level indicator

Add regeneration salt; only add regeneration salt immediately before starting a wash programme.

Programme progress indicator

Pre-rinse / Pre-wash Washing Drying

Programme end

(1.3)

(0.9) (1.7)

(1.3)

Time

(Min.)

Consumption

Normal Load /

(Half Load / Multizone)

Water

(Litres)

(13.5)

(11.5) (19.5)

(11.5)

Energy

(kWh)

(80)

(60) (98)

(90)

Glasses 40° C

RapidPlus 40° C

Standard 50° C

1) Values may vary in rel ation to usage, e.g.: different loads, water temperatures (above or below 15° C), water hardness and power supply voltage, etc.

2) Reference programme for Test Institute and energy-label.

Light soiling, especially glasses and cups.

Lightly soiled crockery with no dried-on food.

Normally or heavily soiled crockery with dried-on food.

- X 12.5 (10.5) 0.82 (0.78) 60 (59)

- X 13.0 (13.0) 0.85 (0.75) 30 (30)

X X 16.0 (14.5) 1.05 (0.90) 120 (117)

5019 100 91383

(We reserve the right to make technical modifications)

How to use the dishwasher

1. After loading the dishwasher, close the door properly and open the water supply tap.

2. The dishwasher switches on automatically as soon as the programme selector knob is turned.

programme indicator lamps will switch on.

3. Turn the selector knob to select the desired programme.

corresponding indicator lamp lights

If required, select options

up.

(if supplied).

4. Press the Start button to start the selected wash programme.

indicator lamp will light up.

the programmed data cannot be altered by turning the programme selector knob.

once the Start button has been

Note:

pressed, the dishwasher memorises the last programme selected. This information remains in the memory even during interruption of the power supply.

To change the selected programme, press the Start button for about 5 seconds. The Start indicator lamp will switch off. Select a new programme and press the Start button.

if the dishwasher is switched off

Note:

during a wash programme, when switched on again it will resume the wash cycle from where it was interrupted.

Only open the dishwasher door if strictly necessary during a wash cycle and exercise maximum caution. Danger of scalding from steam.

5. To indicate the end of the programme, the Start indicator lamp switches off

and the End indicator lamp (if fitted)

lights up

(for about 30 min.).

One of the

The

The Start

Once set,

6. Once the Start indicator lamp has switched off, turn the programme selector knob to the initial position to switch off the dishwasher.

indicator lamps switch off.

7. Open the door (warning: beware of hot steam). Unload the lower rack before the upper one. Close the water tap.

All the

Upper rack

Half load / Multizone:

If the upper rack the cutlery basket (B) in the upper rack.

Rack height adjustment:

(The dishwasher is delivered with the upper rack in the top position). The rack height can also be changed when loaded.

• To lower: pull out the handles and gently lower the rack.

is to be loaded, place

only

side

two

Please read the user instructions carefully.

Upper and lower rack

• To raise: pull up the until the rack clicks into place.

• The rack must be level on both sides.

Crockery Holders

•Down: cups and long-stemmed glasses.

•

Up: plates.

“Flex 3”: multi-purpose support

• To be used, for example, for longhandled utensils

with the blade facing downwards),

cups and glasses.

• May be used in three different positions (see also “Dishwasher loading instructions” on Page 4).

1. Upon the left-hand side of the rack.

2. Upside-down, towards the centre of the rack.

3. Upside-down, towards the left side.

Glass holder:

side handles

two

(arrange knives

Lower rack

(Half Load / Multizone)

Loading the lower rack greater washing power, especially for plates and saucepans.

only

gives

Plate holders

•(A) may be lowered to increase available space.

Cutlery basket

The cutlery basket ( removed to increase available space.

• It can be placed on the upper rack (B) when the Half load/Multizone function is selected.

• Some models are provided with a grid (D) that can be fitted onto the cutlery basket.

B+C

) can be

+ 2 hidden pages