Whirlpool ADP 8932 BL PROGRAM CHART

Time

(Min.)

(kWh)

Energy

Normal load

Consumption *

Water

(Litres)

5019 100 91156

5.0 0.02 9

12.5 0.82 60

16.0 1.24 91

Start button indicator lamp

Switches on when the dishwasher is operating.

Flashes when a fault occurs.

Switches off at the end of the programme.

Rinsing / Washing

symbol “+” in the table below indicates that

detergent must be added).

Pre-wash

Only lights up for programmes with pre-wash (the

Programme progress indicator

PROGRAMME CHART

Detergent

Drying

Programme end

Pre-wash / Washing

Programme selection and

large

small

recommended load type

compartment

+ +

, for crockery

for routine washes

Recommended programme

with little or no dried-on food.

+ +

, with

for heavily soiled crockery

Recommended programme

dried-on food. Especially suitable for pans and saucepans.

(We reserve the right to make technical modifications)

- -

- +

+ +

Normally or heavily soiled crockery with dried-on food.

Lightly soiled glasses and cups.

Crockery to be washed later.

SENSE: Optimum wash results coupled with maximum

he two sensor-controlled programmes are recommended for routine

nergy savings

ashes.

hey use double sensor technology designed to ensure optimum

Add rinse aid.

Rinse aid level indicator

Salt level indicator

Add regeneration salt.

ash results with minimum water and energy consumption.

and Temperature

Programme Symbol

6th Sense Eco-Normal 40-55° C

Pre-wash

Glasses 40° C

6th Sense Intensive 60-70° C

Bio 50° C

water hardness and power supply voltage.

1) Reference programme for Test Institute and energy-label.

*) Values for normal conditions. Values may vary in relation to usage, e.g.: different loads, water temperatures,

Lower rack

Cutlery basket:

removed to increase available

space.

required position (normal or

The cutlery basket can be removed

to increase available space.

• The plate holders may be

Plate holders:

Height adjustment:

(The dishwasher is delivered with the

upper rack in the top position).

crosswise).

• To remove: pull the handle up.

• To reposition: simply insert in the

handles and gently lower the rack.

• To lower: pull out the two side

The rack height can also be changed

when loaded.

handles until the rack clicks into

place.

• To raise: pull up the two side

sides.

• The rack must be level on both

Upper rack

Quick Reference Guide

glasses.

• Down: cups and long-stemmed

• Up: plates.

Crockery holders:

Daily check list

touch each other.

water circulation.

basket with the handles positioned

downwards, but ensure that sharp

knives and forks that might cause

injury are placed in the basket with the

handles positioned upwards.

loaded items and that the spray arms

1. Arrange crockery so that items do not

2. Load cups at an inclination to facilitate

3. In general, place the cutlery in the

4. Make sure the water jet can reach all

rotate freely.

5. Turn on the water supply tap before

starting the dishwasher.

• Switch off the dishwasher once the

Important

“Start” indicator lamp has switched

off. If the dishwasher is turned off

during the washing programme, it will

start again from the same point in the

programme when it is turned back on.

the current programme, press the

“START” button for about 5 seconds

until the Start indicator lamp switches

• If a fault occurs or you wish to change

sideways.

• The glass holder can be moved

• Below: small glasses.

added, IMMEDIATELY start a

washing programme, in order to

• Above: long-stemmed glasses.

eliminate any residual salt.

• Sometimes even when the

regeneration salt container is full,

the corresponding indicator lamp

may illuminate during the first wash

Glass holder:

off! Refer to the “Troubleshooting

Guide” in these user instructions to

remedy any problems.

• If a regeneration salt is to be

cycle.