Whirlpool ADP 8400 WH INSTRUCTION FOR USE

ADP 8400

Quick Reference Guide

Further indications are given in the pages to follow and in the user instructions.

Options

Rinse aid level indicator

Add rinse aid.

Salt level indicator

Add regeneration salt; only add regeneration salt immediately before starting a wash programme.

Programme Symbol

and Temperature

Pre-wash

Rapid 40° C

Bio-Normal 50° C

Intensive 70° C

1) Values may vary in relation to usage, e.g.: different loads, water temperatures - above or below 15° C -, water hardness and power supply voltage, etc.

2) Reference programme for Test Institute and energy-label.

Programme selection and

recommended load type

Crockery to be washed later.

Lightly soiled crockery with no dried-on food.

Normally soiled crockery.

Heavily soiled pans and saucepans.

Delayed start button

The wash cycle can be programmed to start after 3-6-9 hours.

Then press the Start button. The dishwasher will start at the set time.

Programme selector

Start button

Indicator lamp lit while the dishwasher is operating. Flashes when a fault occurs. Switches off at the end of the programme.

Place the detergent in the:

small large

compartment compartment

Water

(Litres)

--8.00.0212

- X 15.0 0.85 31

X X 19.0 1.40 133

X X 24.0 1.90 111

Consumption

Normal load

Energy

(kWh)

Time

(Min.)

5019 100 91387

(We reserve the right to make technical modifications)

How to use the dishwasher

1. After loading the dishwasher, close the door properly and open the water supply tap.

2. The dishwasher switches on automatically as soon as the programme selector knob is turned.

One of the programme indicator lamps will switch on.

3. Turn the selector knob to select the desired programme. The corresponding indicator lamp lights up. If required, select options (if supplied).

4. Press the Start button to start the selected wash programme. The Start indicator lamp will light up. Once set, the programmed data cannot be altered by turning the programme selector knob.

once the Start button has been

Note:

pressed, the dishwasher memorises the last programme selected. This information remains in the memory even during interruption of the power supply.

To change the programme selected, press the Start button for about 5 seconds. The Start indicator lamp will switch off. Select a new programme and press the Start button.

Note:

if the dishwasher is switched off

during a wash programme, when switched on again it will resume the wash cycle from where it was interrupted.

Only open the dishwasher door if strictly necessary during a wash cycle and exercise maximum caution. Danger of scalding from steam.

5. To indicate the end of the programme, the Start indicator lamp switches off and the End indicator lamp (if fitted) lights up (for about 30 min.).

6. Once the Start indicator lamp has switched off, turn the programme selector knob to the initial position to switch off the dishwasher. All the

indicator lamps switch off.

7. Open the door (warning: beware of hot steam). Unload the lower rack before the upper one. Close the water tap.

Upper rack

Upper and lower rack

Crockery holders:

• Down: cups and long-stemmed glasses.

•

Up: plates.

Glass holder:

• The glass holder can be moved sideways.

• Below: small glasses.

• Above: long-stemmed glasses.

Glass holder:

Lower rack

Plate holders:

•(A) May be lowered to increase available space.

Cutlery basket:

• The cutlery basket (C) can be removed to increase available space.

• Some models are provided with a grid (D) that can be fitted onto the cutlery basket.

Please read the user instructions carefully.

+ 2 hidden pages