Whirlpool ADP 6736 IX INSTRUCTION FOR USE

Before using the dishwasher, read the user instructions!

ADP 6736

Quick Reference Guide

Options

Programme selection button

On / Off button

Start button

Switches “on” when the dishwasher is
operating. Flashes when a fault occurs.
Switches off at the end of the programme.

Indicators

Add regeneration salt

Only add regeneration salt immediately
before starting a wash programme.

Add rinse aid

Programme chart

Programmes Loading instructions A B

Pre-Rinse cold
Glass 40°C
Quickwash 40°C

5)

Eco
Normal
Normal

Intensive

1) Reference programme for energy label in c ompliance with
EN 50242 regulations;

2) Refer to “User instructions”;

3) Programme data obtained in conformity with European
standard EN 50242. Values may vary in relation to usage,
e.g.: different loads, water temperatures - above or below
15°C - as well as water hardness and power supply
voltage, etc.

Important information for Test Laboratories:
For detailed information on the EN comparison test and other tests, contact the following address:
“[e-mail]”.

Whirlpool is a registered trademark of Whirlpool USA

1) 5)

5)

5)

Crockery to be washed later. - - 5.0 0.02 10
Light soiling, for example glasses

and cups.
Lightly soiled crockery with no

dried-on food.
Normally soiled crockery. X X 13.0 1.35 90

50°C

Normally soiled crockery. X X 16.0 1.05 170

50°C

Normally or heavily soiled

65°C

crockery.
Recommended programme for

heavily soiled crockery, especially

70°C

suitable for pans and saucepans.

4) The bacteria removal efficiency has been tested by the
Institut Pasteur de Lille (France), based on the NF
EN 13697 standard of November 2001.

5) These programmes can be used with the Antibacterial
rinse option.

“Delayed start” button

The wash cycle can be programmed to start
after 3-6-9 hours. Then press the Start
button. The wash programme will start at the
set time.

Antibacterial rinse

This function adds an antibacterial rinse at the
end of the wash cycle, thereby guaranteeing a
perfectly clean and sanitized load. The lamp
will light up when the function is activated. If
the temperature is not maintained during the
antibacterial cycle (e.g. if the door is opened
and remains open for a long time), the lamp
will start blinking to indicate that sanitation is
not guaranteed.

Detergent

X - 13.0 0.90 55

X - 13.0 0.70 30

X X 16.0 1.65 100

X X 17.0 1.90 135

(We reserve the right to make technical modifications)

GB

4)

2)

Consumption

Litres kWh Minutes

3)

5019 396 91597

How to use the appliance

Further indications are given in the single chapters and in the user instructions.

Switch on the appliance

Fill the detergent dispenser

Check the rinse aid level

Check the

regeneration salt level

Load the racks

Close the dishwasher door,

turn on the water tap

Select a programme

Press the ON / OFF button.

Compartment
With each wash cycle.
Compartment
For programmes with pre-wash only.
If using combined action dishwasher

tabs, follow the user instructions!

Mechanical indicator lamp C.
Electric indicator on control panel (if provided).

On models with water softener
system only.

Mechanical indicator lamp D. Electric
indicator on control panel (if provided).

Refer to the dishwasher loading instructions.

The last programme selected will light up.
Select the desired programme (using the specific button or knob).
The corresponding indicator lamp lights up.

A:

B:

ABC

Select additional options

Press the Start button

Wash cycle

Switch off the appliance

Turn off the water tap,

unload the racks

If necessary (and if provided).
The corresponding indicator lamp lights up.

The selected programme is
then memorised (even in the
event of power failure).

Only after the START button has switched off: Press the ON /
All the indicator lamps switch off.

Warning: When the door is opened steam comes out!

Unload the appliance, starting from the lower rack.

“Change programme in progress”

Press the START button for 2 sec. until the
Start indicator lamp switches off.
Select another programme and press the

START button again.

- Only open the dishwasher if necessary
(Warning: beware of hot steam).

- If the appliance is switched off during a
wash cycle, when switched on again it
will resume the cycle from where it was
interrupted.

OFF

button.