Whirlpool ADP 5556/3 WH INSTRUCTION FOR USE

Before using the dishwasher, read the user instructions!

ADP 5556

Indicators

Quick Reference Guide

Programme selector knob

On / Off

Mains

Start button

Switches “on” when the dishwasher is
operating. Flashes when a fault occurs.
Switches off at the end of the programme.

Add rinse aid

Wash cycle

Pre-Rinse Washing Drying

Options

“Delayed start” button

The wash cycle can be programmed
to start after 3-6-9 hours.
Then press the Start button.
The wash progr amm e wi ll start at t h e
set time.

GB

Programme

end

Add regeneration salt

Only add regeneration salt immediately
before startin g a wash programme.

Programme chart

Programmes Loading instructions A B Litres kWh Minutes

Pre-Rinse cold

Quickwash 40°C

Normal

1)

Normal 65°C

Intensive 70°C

1) Reference programme f or energy label in compliance with
EN 50242 regulations;

2) Refer to “User instructions“;

Important information for Test Laboratories:
For detailed information on the EN comparison test and other tests, contact the following address: “[e-mail]”.

Whirlpool is a registered trademark of Whirlpool USA

Crockery to be washed later. - - 5.0 0.02 10

Lightly soiled crockery, with no
dried-on food.

Normally soiled crockery. X X 16.0 1.05 130

50°C

Normally or heavily soiled crockery. X X 16.0 1.65 100

Recommended programme for heavily
soiled crockery, especially suitable for
pans and saucepans.

3) Program data obtained in conformity with European st andar d
EN 50242. Values may vary in relation to usage, e.g.:
different loads, water te mperatures - above or belo w 15 °C ­as well as water hardness and power supply voltage, etc.

Detergent

(We reserve the right to make technical modifications)

2)

Consumption

X - 13.0 0.70 30

X X 17.0 1.90 135

5019 396 91423

3)

WH/I/K/GB

How to use the appliance

Further indications are given in the single chapters and in the user instructions.

Switch on the appliance

How to fill the

detergent dispenser

Check the rinse aid level

Check the regeneration

salt level

Load the racks

Close the dishwasher door,

turn on the water tap

Select a programme

Automatic start by turning the programme selector knob (in case of
retractable knob, first press the knob to access it).

Large compartment A:
With each wash cycle.
Small compartment B:
For programmes with pre-wash only.

Mechanical indi cator C.
Electric indicator on control panel (if provided).

On models with water softener
system only.

Mechanical indicator D. Electric
indicator on control panel (if provided).

Refer to the dishwasher loading instructions.

Select the desired programme.
The corresponding indicator lamp comes on.

ABC

Select options

Press the Start button

Wa sh cy cle

Switch off the appliance

Turn off the water tap,

unload the racks

If necessary (and if provided) the corresponding indicator lamp lights up.

The selected programme is
then memorised (even in the
event of power failure).

Only after the START button has switched off: Access the knob (in case of
retractable knob, press and then release the knob).

Warning: when the door is opened steam comes out!

Unload the appliance, starting from the lower rack.

“Change programme”

Press the START button for 2 sec. un til
the Start indicator lamp switches o ff;

Select another programme and
press the START button again.

- Only open the dishwasher if necessary
(Warning: beware of hot steam).

- If the appliance is switched o ff d urin g a
wash cycle, when switched on again it
will resume the cycle from where it was
interrupted.

WH/II/K/GB