Whirlpool ADP 5556/1 WHM, ADP 5556/2 WHM INSTRUCTION FOR USE

Before using the dishwasher, read the user instructions!

/K/G

ADP 5556

Indicators

Quick Reference Guide

Program selector knob

On / Off

Mains

Start button

Switches “on” when the dishwasher is operating. Flashes when a fault occurs. Switches off at the end of the programme.

Add rinse aid

Add regeneration salt

Only add regeneration salt immediately before starting a wash programme.

Wash cycle

Pre-wash Washing Drying

Options

“Half load - Multizone” button

Load the upper or lower rack This function can be used with any programme. Press once = upper rack (the indicator lamp comes on) Press twice = lower rack (the indicator lamp comes on) Press 3 times = Off (half load function deactivated).

“Delayed start” button

The wash cycle can be programmed to start after 3-6-9 hours. Then press the Start button. The wash programme will start at the set time.

Programme

end

only

Programme chart

Programmes Loading instructions A B Litres kWh Minutes

Crockery to be washed later. - - 4.0 0.03 14

Pre-Rinse

Quickwash

Normal

Intensive

1) Reference programme for energy label in compliance with EN 50242 regulations;

2) Refer to “User instructions“;

Whirlpool is a registered trademark of Whirlpool USA

cold

Lightly soiled crockery with no dried-on food. X - 10.0 0.65 30

40°C

Normally soiled crockery. X X 13.0 1.24 128

50°C

Normally or heavily soiled crockery. X X 13.0 1.45 90

65°C

Recommended programme for heavily soiled crockery, especially suitable for pans and

70°C

saucepans.

Detergent

3) Values may vary in relation to usage, e.g.: different loads, water temperatures - above or below 15°C - as well as water hardness and power supply voltage, etc.

Consumption

X X 20.0 2.00 125

5019 396 91125

(We reserve the right to make technical modifications)

WH/I

How to use the appliance

Further indications are given in the single chapters and in the user instructions.

Switch on the appliance

How to fill the detergent

Check the rinse aid level

Check the regeneration

salt level

Load the racks

Close the dishwasher door,

turn on the water tap

Select a programme

Automatic start by turning the programme selector knob (in case of retractable knob, first press the knob to access it).

Large compartment A: With each wash cycle. Small compartment B: For programmes with pre-wash only.

Mechanical indicator lamp C. Electric indicator on control panel (if provided).

On models with water softener system only.

Mechanical indicator lamp D. Electric indicator on control panel (if provided).

Refer to the dishwasher loading instructions.

Select the desired programme. The corresponding indicator lamp comes on.

Select options

Press the Start button

Wash cycle

Switch off the appliance

Turn off the water tap,

unload the racks

If necessary (and if provided) the corresponding indicator lamp lights up.

The selected programme is then memorised (even in the event of power failure).

Only after the START button has switched off: Access the knob (in case of retractable knob, press and then release the knob).

Warning: when the door is opened steam comes out!

Unload the appliance, starting from the lower rack.

“Change programme”

Press the START button for 2 sec. until the Start indicator lamp switches off;

Select another programme and press the START button again.

- Only open the dishwasher if necessary (Warning: beware of hot steam).

- If the appliance is switched off during a wash cycle, when switched on again it will resume the cycle from where it was interrupted.

WH/II/K/GB

+ 2 hidden pages