Whirlpool ADP 4731 WH INSTRUCTION FOR USE

Before using the dishwasher, read the user instructions!

ADP 4731

Indicators

Quick Reference Guide

Programme selector knob

ON / OFF button

Start button

Switches “on” when the dishwasher is
operating. Flashes when a fault occurs.
Switches off at the end of the programme.

Add regeneration salt

Only add regeneration salt immediately
before starting a w as h programme.

Add rinse aid

Options

GB

Time and failure display

Indicates in hours the time remaining until
the start of the wash cycle. Switches off
when the programme has started. Toward the
end of the programme, during the drying
cycle, the display will indicate the time
remaining in minutes.

“F....” Identification of faults for service

technician

“Delayed start” buttons

The wash cycle can be programmed to start
after 1 - 24 hours. With each successive
touch of the button, the delayed start
indicator increases by 1 hour, and after 24
returns to 00. Then press the Start button.
The dishwasher will start at the set time.

Antibacterial rinse

This function adds an antibacterial rinse at
the end of the wa sh cycle, thereby
guaranteeing a perfec tly cl ean and sanitized
load. The lamp will light up wh en the functi on
is activated. If the temperature is not
maintained during th e antibacterial cycle (e .g.
if the door is opened and remains open for a
long time), the lamp will start blinking to
indicate that sanitation is not guaranteed.

3)

4)

Programme chart

Detergent

Programmes Loading instructions A B

Pre-Rinse cold
Glasses 40°C
Quickwash 40°C

5)

Eco
Eco Normal
Normal

Intensive

1) Reference programme for energy label in compliance with
EN 50242 regulations;

2) Refer to “User instructions“;

3) Program data obtained in conformity with European standard EN

50242. V alues may vary in r elation to usage , e .g.: different loads,
water temperatures - above or below 15°C - as well as water
hardness and power supply voltage, etc.

Important information for Test Laboratories:
For detailed information on the EN comparison test and other tests, contact the following address: “[e-mail]”.

Whirlpool is a registered trademark of Whirlpool USA

1) 5)

5)

5)

Crockery to be washed later. - - 5.0 0.02 10
Light soiling, for example glasses

and cups.
Lightly soiled crockery with no

dried-on food.
Normally soiled crockery. X - 13.0 1.35 90

50°C

Normally soiled crockery. X X 16.0 1.05 120

50°C

Normally or heavily soiled crockery. X X 16.0 1.65 100

65°C

Recommended programme for
heavily soiled crockery, especially

70°C

suitable for pans and saucepans.

4) The bacteria removal efficiency has been tested by the Institut
Pasteur de Lille ( France), based on the NF EN 13697 standard of
November 2001.

5) These programmes can be used with the Antibacterial rinse
option.

(We reserve the right to make technical modifications)

2)

Consumption

Litres kWh Minutes

X - 13.0 0.90 55

X - 13.0 0.70 30

X X 17.0 1.90 135

5019 396 98055

3)

WH/I/B/GB

How to use the appliance

Further indications are given in the single chapters and in the user instructions.

Switch on the appliance

How to fill the

detergent dispenser

Check the rinse aid level

Check the regeneration

salt level

Load the racks

Close the dishwasher door,

turn on the water tap

Select a programme

Press the ON/OFF button.

Large compartment A:
With each wash cycle.
Small compartment B:
For programmes with pre-wash only.

Mechanical indi cator C.
Electric indicator on control panel (if provided).

On models with water softener
system only.

Mechanical indicator D. Electric
indicator on control panel (if provided).

Refer to the dishwasher loading instructions.

The last programme selected will light up.
Select the desired programme (using the specific button or knob).
The corresponding indicator lamp lights up.

ABC

Select options

Press the Start button

Wa sh cycle

Switch off the appliance

Turn off the water tap,

unload the racks

If necessary (and if provided) the corresponding indicator lamp lights up.

The selected programme is
then memorised (even in the
event of power failure).

Only after the START button has switched off: Press the ON/OFF button.
All the indicator lamps switch off.

Warning: when the door is opened steam comes out!

Unload the appliance, starting from the lower rack.

“Change progra mme”

Press the START button for 2 sec. until
the Start indicator lamp switches off;

Select another programme and press
the START button again.

- Only open the dishwasher if necessary
(Warning: beware of hot steam).

- If the appliance is switched o ff d urin g a
wash cycle, when switched on again it
will resume the cycle from where it was
interrupted.

WH/II/B/GB