Whirlpool ADP 4610 WH INSTRUCTION FOR USE

Before using the dishwasher, read the user instructions!

ADP 4610

Indicators

Programmes Loading instructions A B

Quick Reference Guide

Programme selector knob

ON / OFF button

Start button

Switches “on” when the dishwasher is
operating. Flashes when a fault occurs.
Switches off at the end of the programme.

Add regeneration salt

Only add regeneration salt immediately
before starting a wash programme.

Add rinse aid

Programme chart

Options

GB

“Delayed start” button

The wash cycle can be programmed to start after
3-6-9 hours. Then press the Start button. The wash
programme will start at the set time.

“Half Load” button

The half load cycle can be used for the upper and
lower rack. Select the required programme then
press the “Half Load” button. The light comes on
and goes off at the end of the programme.
The “Half Load” function can be used with
programmes marked with an *.

Antibacterial rinse

This function adds an antibacterial rin se at th e end
of the wash cycle, thereby guaranteeing a perfectly
clean and sanitized load. The lamp will ligh t up when
the function is activated. If the temperature is not
maintained during th e an tibacterial cycle (e.g. if the
door is opened and remains open for a long time),
the lamp will start blinking to indicate that
sanitation is not guaranteed.

Detergent

4)

2)

Consumption

Litres kWh Minutes

3)

Pre-Rinse cold
Quickwash 40°C

*) 5)

Eco

1) *) 5)

Normal

*) 5)

Normal

Intensive

1) Reference programme for energy label in compliance with
EN 50242 regulations;

2) Refer to “User instructions“;

3) Program data obtained in conformity with European standard EN

50242. Values may vary in relation to usage, e.g.: different loads,
water temperatures - above or below 15°C - as well as water
hardness and power supply voltage, etc.

Important information for Test Laboratories:
For detailed information on the EN comparison test and other tests, contact the following address: “[e-mail]”.

Whirlpool is a registered trademark of Whirlpool USA

5)

Crockery to be washed later. - - 5.0 0.02 10

Lightly soiled crockery with no dried-on food. X - 13.0 0.70 30

Normally soiled crockery. X - 13.0 1.35 90

50°C

Normally soiled crockery. X X 16.0 1.05 160

50°C

Normally or heavily soiled crockery. X X 16.0 1.65 100

65°C

Recommended programme for heavily soiled
crockery, especially suitable for pans and

70°C

saucepans.

4) The bacteria removal efficiency has been tested by the Institut
Pasteur de Lille (France), based on the NF EN 13697 standard of
November 2001.

5) These programmes can be used with the Antibacterial rinse
option.

X X 17.0 1.90 135

5019 396 98067

(We reserve the right to make technical modifications)

WH/I/B/GB

How to use the appliance

Further indications are given in the single chapters and in the user instructions.

Switch on the appliance

How to fill the

detergent dispenser

Check the rinse aid level

Check the regeneration

salt level

Load the racks

Close the dishwasher door,

turn on the water tap

Select a programme

Press the ON/OFF button.

Large compartment
With each wash cycle.
Small compartment
For programmes with pre-wash only.

Mechanical indicator C.
Electric indicator on control panel (if provided).

On models with water softener
system only.

Mechanical indicator D. Electric
indicator on control panel (if provided).

Refer to the dishwasher loading instructions.

The last programme selected will light up.
Select the desired programme (using the specific button or knob).
The corresponding indicator lamp lights up.

A:

ABC

B:

Select options

Press the Start button

Wash cycle

Switch off the appliance

Turn off the water tap,

unload the racks

If necessary (and if provided) the corresponding indicator lamp lights up.

The selected programme is
then memorised (even in the
event of power failure).

Only after the START button has switched off: Press the ON/
All the indicator lamps switch off.

Warning: when the door is opened steam comes out!

Unload the appliance, starting from the lower rack.

“Change programme”

Press the START button for 2 sec. until
the Start indicator lamp switches off;

Select another programme and press
the START button again.

- Only open the dishwasher if necessary
(Warning: beware of hot steam).

- If the appliance is switched o ff d urin g a
wash cycle, when switched on again it
will resume the cycle from where it was
interrupted.

OFF

button.

WH/II/B/GB