Whirlpool ADG 9557, AWM 6122 INSTRUCTION FOR USE
Before using the dishwasher, read the user instructions!
ADG 9557
Indicators
Quick Reference Guide
On button
Off button
Programme selection button
Start button
Switches “on” when the dishwasher is
operating. Flashes when a fault occurs.
Switches off at the end of the programme.
Add rinse aid
GB
Options
“Delayed start” button
The wash cycle can be programmed
to start after 3-6-9 hours. Then
press the Start button.
The wash programme will start at
the set time.
“Half load” button
The half load cycle can be used for
the upper and lower rack. Select the
required programme then press the
“Half Load” button. The light com e s
on and goes off at the end of the
programme.
The “Half Load” function can be used
with programmes marked with an *.
Add regeneration salt
Only add regeneration salt immediately
before starting a wash programme.
Programme chart
Detergent
2)
Consumption
3)
Programmes Loading instructions A B Litres kW h Minutes
Pre-Rinse cold
Quickwash 40°C
Eco-Normal
Antibacterial
1) *)
4) 5)
Intensive 70°C
1) Reference programme f or energy label in compliance with
EN 50242 regulations;
2) Refer to “User instructions“;
3) Program data obtained in conformity with European st andard
EN 50242. Values may vary in relation to usage, e.g.:
different loads, water temperatures - above or below 15°C as well as water hardness and power supply voltage, etc.
Important information for Test Laboratories:
For detailed information on the EN comparison test and other tests, contact the following address: “nk_customer@whirlpool.com”.
Whirlpool is a registered trademark of Whirlpool USA
Crockery to be washed later. - - 5.0 0.02 10
Lightly soiled cr ockery , with no d ried-on
food.
Normally soiled crozpckery. X X 16.0 1.05 160
50°C
Normally or heavily soiled crockery,
with additional antibacterial action.
Recommended programme for heavily
soiled crockery, especially suitable for
pans and saucepans.
4) The bacteria removal efficiency has been tested by the
Institut Pasteur de Li lle (France) , based on the NF EN 13697
standard of November 2001.
5) Programme interruption (e.g . the door being opened) may
compromise the result of the antibacterial rinse.
X - 13.0 0.70 30
X X 16.0 1.75 120
X X 17.0 1.90 135
5019 396 91497
(We reserve the right to make technical modifications)
WH/I/FD/GB
How to use the appliance
Further indications are given in the single chapters and in the user instructions.
Open the door,
switch on the appliance
How to fill the
detergent dispenser
Check the rinse aid level
Check the regeneration
salt level
Load the racks
Select a programme
Select options
Press the ON button.
Large compartment A:
With each wash cycle.
Small compartment B:
For programmes with pre-wash only.
Mechanical indicator C.
Electric indicator on control panel (if provided).
On models with water softener system only .
Mechanical indi cator D. Electri c indi cator
on control panel (if provided).
Refer to the dishwasher loading instructions.
The last programme selected will light up.
Press the button until the desired programme lights up.
If necessary (and if provided)
the corresponding indicator lamp lights up.
ABC
Press the Start button
Turn on the water tap
close the dishwasher door
Wa sh cycle
Switch off the appliance
Turn off the water tap,
unload the racks
The selected progr amme is then
memorised (even in th e event
of power fai lur e).
At the end of the progr amme an acoustic sign al will sound.
Only after the ST ART button has switched o ff: press th e OFF button.
All the indi cator lamps switch off.
Warning: when the door is opened steam comes out!
Unload the appliance, starting from the lower rack.
“Change progra mme”
Press the START button for 2 sec. until
the Start indicator lamp switches off;
Select another programme and press
the START button again.
- Only open the dishwasher if necessary
(Warning: beware of hot steam).
- If the appliance is switched o ff d urin g a
wash cycle, when switched on again it
will resume the cycle from where it was
interrupted.
WH/II/FD/GB
Loading...