Whirlpool ADG 9556 M INSTRUCTION FOR USE

Before using the dishwasher, read the user instructions!

ADG 9556

Indicators

Quick Reference Guide

On button

Off button

Programme selection button

Start button

Switches “on” when the dishwasher is
operating. Flashes when a fault occurs.
Switches off at the end of the programme.

GB

Options

“Delayed start” button

The wash cycle can be programmed
to start after 3-6-9 hours.
Then press the Start button.
The wash programme will start at the
set time.

“Half load” button

This function can be used with any
programme.
The indicator lamp switches on.
The wash cycle is activated for the
upper or lower rack only.

Add rinse aid

Add regeneration salt

Only add regeneration salt immediately
before starting a wash programme.

Programme chart

Programmes Loading instructions A B Litres kWh Minutes

Pre-Rinse cold

Quickwash 40°C

Normal

1)

Normal 65°C

Intensive 70°C

1) Reference programme for energy label in compliance with
EN 50242 regulations;

2) Refer to “User instructions“;

Crockery to be washed later. - - 4.0 0.03 14
Lightly soiled crockery, with no dried-on

food.
Normally soiled crockery. X X 13.0 1.24 128

50°C

Normally or heavily soiled crockery. X X 13.0 1.45 90
Recommended programme for heavily soiled

crockery, especially suitable for pans and
saucepans.

Detergent

3) Values may vary in relation to usage, e.g.: different loads,
water temperatures - above or below 15°C - as well as water
hardness and power supply voltage, etc.

2)

Consumption

X - 10.0 0.65 30

X X 20.0 2.00 125

3)

Whirlpool is a registered trademark of Whirlpool USA

(We reserve the right to make technical modifications)

5019 396 91172

WH/I/FD/GB

How to use the appliance

Further indications are given in the single chapters and in the user instructions.

Open the door,

switch on the appliance

How to fill the

detergent dispenser

Check the rinse aid level

Check the regeneration

salt level

Load the racks

Select a programme

Select options

Press the ON button.

Large compartment A:
With each wash cycle.
Small compartment B:
For programmes with pre-wash only.

Mechanical indicator lamp C.
Electric indicator on control panel (if provided).

On models with water softener system only.

Mechanical indicator lamp D. Electric
indicator on control panel (if provided).

Refer to the dishwasher loading instructions.

The last programme selected will light up.
Press the button until the desired programme lights up.

If necessary (and if provided)
the corresponding indicator lamp lights up.

AB

C

Press the Start button

Turn on the water tap

close the dishwasher door

Wash cycle

Switch off the appliance

Turn off the water tap,

unload the racks

The selected programme is then
memorised (even in the event
of power failure).

At the end of the programme an acoustic signal will sound.
Only after the START button has switched off: press the OFF button.
All the indicator lamps switch off.

Warning: when the door is opened steam comes out!

Unload the appliance, starting from the lower rack.

“Change programme”

Press the START button for 2 sec. until
the Start indicator lamp switches off;

Select another programme and
press the START button again.

- Only open the dishwasher if necessary
(Warning: beware of hot steam).

- If the appliance is switched off during a
wash cycle, when switched on again it
will resume the cycle from where it was
interrupted.