Page 1
3GB96004.fm Page 1 Wednesday, September 15, 2004 2:35 PM
Before using the dishwasher, read the user instructions!
ADG 689
Indicators
Quick Reference Guide
Programme ON/OFF selector knob
First press and release the selector knob to access it,
and then turn it to select the desired programme;
the dishwasher switches on.
To switch off the dishwasher when the programme
has finished, turn the selector knob to o ff.
Start button
Press to start the wash cycle and keep pr essed un til
an acoustic signal confirms the start of the wash
cycle. The display shows the approximate duration
of the wash cycle.
the light above the start button blinks durin g
Note:
the wash cycle.
The light stops blinking and remains alight to
indicate the cycle has ended (“En d” on th e display)
or has been interrupted due to a fault
(“E1, E2....” on the display).
Add rinse aid
Options
GB
“Eco Dry” button
Press the button to active drying using the
energy-saving ventilation system.
“Delayed start” button
The wash cycle can be programmed to start after
1-12 hours. Then press the Start button. After a
prewash the set delay will start.
Display
The display shows all the information relating to
the functions selected.
Add regeneration salt
Only add regeneration salt immediately before
starting a wash programme.
Programme chart
Programmes Loading instructions A B Litres kWh Minutes
P1
P2
P3
P4
P5
P6
P7
P8
1) Reference programme for energy label in compliance with EN 50242 (the
reference cycle refers to a c y cle with the “Eco Dry” function selected);
2) Refer to “User instructions“;
Whirlpool is a registered trademark of Whirlpool USA
Pre-Rinse cold
4)
Delicate
Rapid 30 min 45°C
4)
Normal
4)
Universal
4)
Bio
1) 4)
Eco
4)
Intensive
Crockery to be washed later. - - - 5.0 0.02 9
Light soiling, for example glasses and cups X X - 12.0 0.90 79
45°C
Lightly soiled crockery with no dried-on food. - X - 13.0 0.35 30
Normally or heavily soiled crockery. X X X 17.0 1.18 100
65°C
Normally or heavily soiled crockery. X X - 13.0 1.23 100
65°C
Normally or lightly soiled crock ery, with dried-on food X X X 17.0 1.08 108
55°C
Normally soiled crockery. X X - 13.0 1.01 160
55°C
Recommended programme f or h eavily soiled cr ockery,
70°C
especially suitable for pans and saucepans.
2)
Detergent
Eco
Dry
X X X 20.0 1.48 125
3) Programme data obtained in conformity with European standard
EN 50242. Values may vary in relation to usage, e.g.: different loads,
water temperatures - above or below 15° C - as w ell as w ater har dness
and power supply voltage, etc.
4) Programmes with “Eco Dry” last approx. 30 min. more.
Consumption
5019 396 96004
(We reserve the right to make technical modifications)
3)
Black process 45.0° 100.0 LPI
Page 2
D
Wash cycle
3GB96004.fm Page 2 Wednesday, September 15, 2004 2:35 PM
How to use the appliance
Further indications are given in the single chapters and in the user instructions.
Open the door
How to fill the
detergent dispenser
Check the rinse aid level
Check the
regeneration salt level
Load the racks
Close the door,
select a programme
Select
additional options
Press the Start button
to start the programme
(during the cycle the
Start indicator blinks)
Large compartment
A
B
Small compartment
Mechanical indicator lamp C.
Electric indicator on control panel (if provided).
On models with water softener system
only.
Mechanical indicator lamp D.
Electric indicator on control panel
(if provided).
Refer to the dishwasher loading instructions.
Press and turn the selector kn ob to select the desired progr amme an d
switch on the appliance.
If necessary (and if provided).
The corresponding indicator lamp lights up.
“Cancel”
Press and hold the “Start” button
until the indicator lamp stops
blinking and stays on.
Press and hold the “Start” button
for 10 seconds. “P0” will appear on
the display and the programme will
stop.
B
“Change programme in progress”
Press and hold the “Start” button
until the indicator lamp stops
blinking and stays on.
Select and start the programme as
described previously.
C
A
Black process 45.0° 100.0 LPI
Turn on the water tap
Switch off the appliance
Turn off the water
tap, unload the racks
- Only open the dishwasher if
necessary (Warning: beware of hot
steam).
- If the appliance is switched off
during a wash cycle, when
switched on again it will resume
the cycle from where it was
interrupted.
To switch off the dishwasher turn the selector knob to off.
All the indicator lamps and the display switch off.
Warning: When the door is opened steam comes out!
Unload the appliance, starting from the lower rack.
Page 3
3GB96004.fm Page 3 Wednesday, September 15, 2004 2:35 PM
Dishwasher loading instructions and racks provided
Upper rack:
Crockery holder (A):
Depending on the position: up or
down.
Long-handled utensils, cups and
glasses. Place the glasses to the
side of the rack or holders.
Place long and narrow utensils in
the centre of the rack or holders.
Long-handled utensils (e.g.
carving forks, knives) must be
arranged with the sharp end
facing in towards the appliance.
Rack height adjustment:
Release the caps (B) of both rack
rails.
Take the rack out.
Reposition the rack at the desired
height.
Close the caps (B).
The rack must be level on both
sides.
A
depending on the model
A
A
B
A
B
Lower rack:
Depending on the model with fixed
or tilting plate holders.
Cutlery basket:
Some models are provided with a
grid (C) that can be fitted onto the
cutlery basket to keep items
separated.
Sharp knives and forks that might
cause injury must be placed in
the cutlery basket with the sharp
end facing downwards.
Only use dishwasher-proof crockery and dishes. Do not use the appliance for items not suitable for washing in a
dishwasher, for example wooden items, aluminium, plastic utensils, tin, hand-decorated crockery (unglazed), silver
cutlery.
Black process 45.0° 100.0 LPI
C
C
C
C
Page 4
3GB96004.fm Page 4 Wednesday, September 15, 2004 2:35 PM
What to do if...
If a fault occurs, before contacting our After-Sales Service, make the following checks to try and remedy the problem (* see
also the corresponding chapter in the user instructions).
Problem Cause Remedy
The appliance is not
working
If crockery is not
perfectly dry
If crockery is not
perfectly clean
Sandy or grainy residues
Colour of plastic parts
faded
• No water supply. • Open the tap.
• The appliance does not load sufficient
water.
• There is a power failure. • Insert the plug into the mains socket.
• Insufficient rinse aid. • Increase dosage *.
• Residual water in cavities. • Load crockery at an angle.
• The water jet does not reach the
crockery.
• Insufficient detergent. • Follow recommended detergent dosage.
• Unsuitable programme. • Select a more intense wash cycle.
• Spray arms blocked. • The spray arms must be able to turn freely.
• Spray arm nozzles clogged. • Remove any impurities obstructing the water flow *.
• Incorrect detergent/detergent too old. • Use a good quality detergent.
• Clogged filters. • Check filters regularly/if necessary clean *.
• Filters incorrectly assembled. • Insert the filter correctly *.
• Tomato/carrot juice,... • Depending on the material, if necessary use a
• Clean the water supply tap filter.
• Ensure there are no kinks in the water hose.
• Open the door.
• Close the door.
• Check the domestic circuit fuse.
• Arran g e crock ery so that item s d o not tou ch each oth er.
Load crockery upside down.
detergent with a greater whitening power.
Deposits on crockery
•removable • Streaks on the crockery/glasses. • Reduce the rinse aid dosage *.
• Layer of salt on crockery/glasses. • Close the salt container lid properly *.
•not removable • Insufficient water softening, calcium
Opaque glasses/
deposits.
• Cannot be washed in the dishwasher. • Use suitable glasses.
• Change water hardness setting, if necessary add s alt *.
glasses not sparkling
Rust on cutlery
See the user instructions for the troubleshooting table with possible faults.
If after carrying out the above checks the malfun ction persists or appears again, turn th e applianc e off and turn o ff the w ater
supply tap, then call our After-Sales Service (see guarantee).
Before contacting our After-Sales Service, take note of the following:
• The nature of the fault.
• The appliance type and model.
• The service code (the number indicated on the adhesive rating plate)
inside the d oor on the right-hand side .
Black process 45.0° 100.0 LPI
• Not made of stainless steel. • Use suitable cutlery.
Loading...