GB
ADG 6452
Quick Reference Guide
Further indications are given in the pages to follow and in the user instructions.
Programme selector
Start button
Indicator lamp lit while the dishwasher is operating.
Flashes when a fault occurs.
Switches off at the end of the programme.
Programme Symbol
and Temperature
Pre-wash
Rapid 30’
Eco 50° C
Intensive 70° C
1) Values may vary in relation to usage, e.g.: different loads, water
temperatures (above or below 15° C), water hardness and power supply voltage, etc.
2) Programme recommended when using detergents of type B (enzyme-based detergents).
Reference programme for energy label.
2)
Crockery to be washed later.
Lightly soiled crockery with no dried-on food.
Normally or heavily soiled crockery with dried-on food.
Heavily soiled pans and saucepans.
Programme selection and
recommended load type
Rinse aid level indicator
Add rinse aid.
Salt level indicator
Add regeneration salt; only add regeneration
salt immediately before starting a wash
programme.
Place the detergent in the:
small
compartment
- - 5.0 0.02 9
- X 13.0 0.85 30
X X 16.0 1.24 135
X X 21.0 1.90 110
large
compartment
Water
(Litres)
Consumption
Normal load
Energy
(kWh)
5019 100 91343
(We reserve the right to make technical modifications)
1)
Time
(Min.)
How to use the dishwasher
1. After loading the dishwasher, close the
door properly and open the water
supply tap.
2. The dishwasher switches on
automatically as soon as the programme
selector knob is turned.
programme indicator lamps will
switch on.
3. Turn the selector knob to select the
desired programme.
indicator lamp lights up.
select options (if supplied).
4. Press the Start button to start the
selected programme.
indicator lamp will light up.
the programmed data cannot be
altered by turning the programme
selector knob.
Note:
once the Start button has been
pressed, the dishwasher memorises the
last programme selected. This
information remains in the memory even
during interruption of the power supply.
To change the selected
programme, press the Start button
for about 5 seconds
Start indicator lamp switches
off.
Select a new programme and
press the Start button.
Note:
If the dishwasher is switched off
during a wash programme, when
switched on again it will resume the wash
cycle from where it was interrupted.
Only open the dishwasher door if
strictly necessary during a wash
cycle and exercise maximum
caution. Danger of scalding from
steam.
5. To indicate the end of the programme,
the Start indicator lamp switches off
the End indicator lamp (if fitted)
and
lights up
(for about 30 min.)
One of the
The corresponding
If required,
The Start
Once set,
, until the
.
6. Once the Start indicator lamp has
switched off, turn the programme
selector knob to the initial position to
switch off the dishwasher.
indicator lamps switch off.
7. Open the door (warning: beware of hot
steam). Unload the lower rack before
the upper one. Close the water tap.
All the
Upper rack
Rack height adjustment:
(The dishwasher is delivered with the upper
rack in the top position).
The rack height can also be changed
when loaded.
Upper and lower rack
• To lower: pull out the
handles and gently lower the rack.
• To raise: pull up the
until the rack clicks into place.
• The rack must be level on both
sides.
Crockery holders:
• Down: cups and long-stemmed
glasses.
Up: plates.
•
Glass holder:
two
side
two
side handles
Lower rack
C
Cutlery basket:
• The cutlery basket (C) can be
removed to increase available space.
• Some models are provided with a
grid (D) that can be fitted onto the
cutlery basket.
Please read the user instructions carefully.