Whirlpool 3RLEC8600, 3RLEQ8033 Installation Instructions

INSTALLATION INSTRUCTIONS

ELECTRIC DRYER

8543157

Write down the model and serial numbers before installing dryer.

Both numbers are listed on the model/serial rating plate located
in the dryer door well.

Model # _______________________________

Serial # _______________________________

Date of Purchase _______________________

for models:
3RLEC8600
3RLEQ8033

2

Table of Contents

DRYER SAFETY............................................................................ 2

INSTALLATION REQUIREMENTS .............................................. 3

Tools and Parts .......................................................................... 3

Location Requirements.............................................................. 3

Electrical Requirements ............................................................ 4

Venting Requirements .............................................................. 5

Plan Vent System ...................................................................... 5

INSTALLATION INSTRUCTIONS ............................................ 6

Install Vent System .................................................................... 6

Install Leveling Legs .................................................................. 6

Electrical Connection ................................................................ 7

Level the Dryer .......................................................................... 7

Connect Vent ............................................................................ 7

Complete Installation ................................................................ 7

DRYER SAFETY

Your safety and the safety of others are very important.

We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety
messages.

This is the safety alert symbol.

This symbol alerts you to potential hazards that can kill or hurt you and others.

All safety messages will follow the safety alert symbol and either the word “DANGER” or “WARNING.”

These words mean:

You can be killed or seriously injured if you don't immediately

DANGER

WARNING

All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can
happen if the instructions are not followed.

IMPORTANT SAFETY INSTRUCTIONS

When discarding or storing your old clothes dryer, remove the door.

SAVE THESE INSTRUCTIONS

follow instructions.

can be killed or seriously injured if you don't

You
instructions.

follow

3

Location Requirements

Observe all governing codes and ordinances.

You will need

■ A location that allows for proper exhaust installation. The
dryer must be exhausted to the outdoors. See “Venting
Requirements.”

■ A sturdy floor to support the dryer and a total weight (dryer
and load) of 79.4 kg (175 lb). The combined weight of a
companion appliance should also be considered.

■ A level floor with a maximum slope of 2.5 cm (1") under entire
dryer. (If slope is greater than 2.5 cm [1"], install Extended
Dryer Feet Kit, Part No. 279810.) Clothes may not tumble
properly and models with automatic sensor cycles may not
operate correctly if dryer is not level.

■ It is important to make sure the room has an adequate air
supply for drying operation. The operation of this appliance
may affect the operation of other gas appliances which take
their air supply for safe combustion from the same room. If in
doubt consult the appliance manufacturers.

Do not operate your dryer at temperatures below 7ºC (45ºF). At
lower temperatures, the dryer might not shut off at the end of an
automatic cycle.

The dryer must not be installed or stored in an area where it will
be exposed to water and/or weather.

Check code requirements. Some codes limit, or do not permit,
installation of the dryer in garages, closets, mobile homes, or
sleeping quarters. Contact your local building inspector.

NOTE: No other fuel-burning appliance can be installed in the
same closet as a dryer.

Installation Clearances

The location must be large enough to allow the dryer door to
open fully.

INSTALLATION REQUIREMENTS

Tools and Parts

Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools
listed here.

Tools needed

■ level

■ 20 to 30 cm (8" or l0") adjustable wrench that opens

to 2.5 cm (1")

■ flat-blade screwdriver

■ 1/4" nut driver or socket wrench

■ caulking gun and compound

■ knife

■ duct tape

■ 1" hex-head socket wrench

■ tin snips

Parts supplied

Remove parts bag from dryer drum. Check that all parts were
included.

Parts needed

Check local codes, and read electrical and venting requirements
before purchasing parts.

4 leveling legs

WARNING

Explosion Hazard

Keep flammable materials and vapors, such as gasoline,
away from dryer.

Place dryer at least 46 cm (18 inches) above the floor for
a garage installation.

Failure do to so can result in death, explosion, or fire.