Whirlpool 3RLEC8646 User Manual

8318346

Installation Instructions

Electric Dryer

IMPORTANT:
Read and save these

instructions.

Installer: Leave Installation Instructions with

homeowner.

Homeowner: Keep Installation Instructions

for future reference. For best
performance, install dryer according to
Installation Instructions. Failure to
complete installation as instructed
could void warranty.

Save Installation Instructions for local

inspector’s use.

Introduction

This appliance must be installed in accordance with the rules in force,
and used only in a sufficiently ventilated space.Consult instructions
before installation and use of this appliance.

Have questions about your dryer?

Call your dealer or local authorised service company.
When you call, you will need the dryer model number and serial

number.Both numbers are on the model/serial
rating plate located in the door well behind the
dryer door and on front of opening.

Record the numbers here for handy reference:

Model No.

Serial No.

for models:
3RLER5437
3RLEQ8000
3RLEC8646

2

WARNING: If the information in this
manual is not followed exactly, a
fire or explosion may result causing
property damage, personal injury or
death.

Do Not store or use gasoline, or
other flammable vapours and
liquids in the vicinity of this or any
other appliance.

Before you start... VentingTools and materials

needed for
installation...

Parts supplied for
installation...

Parts needed for
installation...

You can be killed or seriously
injured if you don’t follow
instructions.

DANGER

Your safety and the safety of

others are very important.

We have provided many important
safety messages in this manual
and on your appliance.Always
read and obey all safety
messages.

All safety messages will tell you
what the potential hazard is, tell you
how to reduce the chance of injury,
and tell you what can happen if the
instructions are not followed.

You can be killed or seriously
injured if you don’t immediatel

y

follow instructions.

WARNING

This is the safety alert
symbol.

This symbol alerts you to
potential hazards that can kill or
hurt you and others.

All safety messages will follow the
safety alert symbol and either the
word “DANGER” or “WARNING”.
These words mean:

• level

• gloves

• 20 to 30 cm (8" or l0") adjustable
wrench that opens to 2.5 cm (1")

• flat-blade screwdriver

• safety glasses

• 1/4" nut driver or socket wrench

• caulking gun and compound

• knife

• duct tape

• 1" hex-head socket wrench

• tin snips

4 leveling legs

Remove parts
package from dryer
drum. Check that all
parts were included.

Check local codes, and read electrical
and venting requirements before
purchasing parts.

Fire Hazard
Use a heavy metal vent.
Do not use a plastic vent.
Do not use a metal foil vent.
Failure to follow these instructions

can result in death or fire.

WARNING

Vent system

100 mm (4") metal exhaust vent must
be used.

Exhaust hood
Do Not use exhaust hoods with

magnetic latches.

10,2 cm
(4")

10,2 cm
(4")

6,4 cm
(2-1/2")

Preferred Acceptable

Floors sloped greater than 2.5 cm
(1 inch):

Require Extended Dryer Feet Kit, Part
No.279810 available for purchase
from your dealer.

3

Dryer location and

dimensions

Explosion Hazard

Keep flammable materials and
vapors, such as gasoline, away
from dryer.

Place dryer at least 45.7 cm
(18 inches) above the floor for a
garage installation.

Failure to do so can result in
death, explosion, or fire.

WARNING

The dryer door
extends 35.6 cm
(14") from the
front of the
dryer when fully
opened.

69.9 cm
(27-1/2")

terminal block cover

power supply
cord/cable
strain relief

109.5 cm
(43-1/8")

27.9 cm
(11")

Dimensions shown with feet extended 2.5 cm (1") from bottom of dryer.

97.2 cm
(38-1/4")

68.6 cm (27")

35.6 cm
(14")

left or right
side exhaust

back

exhaust

10.8 cm
(4-1/4")

26 cm

(10-1/4")

35.9 cm
(14-1/8")

10.2 cm
(4")

Exhaust dimensions

For proper drying performance:

The location must provide:

• Protection from weather and
water: Do not store or use dryer
where it will be exposed to water and
weather.

• Room temperature above 7°C
(45°F): If room temperature is below
7°C (45°F), automatic cycles may not
shut off.

• Level floor: Maximum slope under
entire dryer should not be more than

2.5 cm (I inch). If slope is greater
than 2.5 cm (1 inch), install Extended
Dryer Feet Kit, Part No.2798l0.
Clothes may not tumble properly and
automatic sensor cycles may not
operate correctly if dryer is not level.

• Sturdy floor to support dr yer weight
of 79.4 kg (175 pounds).

• Air supply: It is important to make
sure the room has an adequate air
supply for drying operation.The
operation of this appliance may affect
the operation of other gas appliances
which take their air supply for safe
combustion from the same room. If in
doubt consult the appliance
manufacturers.

• Exhaust to outdoors: Dryer must
be exhausted outdoors to prevent
large amounts of lint and moisture
from accumulating and to maintain
drying efficiency.

It is the installer's responsibility to:

• Observe all governing codes and
ordinances.

• Check code requirements: Some
codes limit or do not permit
installation of clothes dryers in
garages, closets, mobile homes or
sleeping quarters. Contact your local
building inspector.

• Comply with the installation
specifications and dimensions.

• Consider spacing requirements for
companion appliances.

• Properly install dryer.

• Check that you have everything
necessary; for proper installation.

• Contact a competent installer to
ensure that the electrical installation
meets all national and local codes
and ordinances.

This installation must also conform
with all national and local codes and
ordinances.