Whelen MBADPT14 User Manual

5/16 x 1 1/4” Hex Head Bolt

Flat Washer

5/16” Elastic Stop Nut

Adapter Plate

Rear Rack

ENGINEERING COMPANY INC.

Secure new deck with existing hardwareSecure new deck with existing hardware

Secure Adapter Plate using the hardware provided.

5/16 x 1 1/4” Hex Head Bolt

Flat Washer

5/16” Elastic Stop Nut

Adapter Plate

Rear Rack

Secure new deck with existing hardwareSecure new deck with existing hardware

Secure Adapter Plate using the hardware provided.

51 Winthrop Road,

Chester, Connecticut 06412-0684

Phone: (860) 526-9504

Fax: (860) 526-4078

Installation:

1. Using an appropriately sized bit, drill a clearance hole for a 5/16 bolt through the existing mounting holes in the rear rack.

2. Position the adapter plate onto the rear rack so that its holes are aligned with the rack holes.

3. Secure the plate loosely to the rack using the hardware provided. Install hardware in the order shown.

4. Tighten the hardware in a criss-cross pattern until a torque value of 138 in/lbs (11.5 ft/lbs) is achieved.

IMPORTANT! It is the responsibility of the installation technician to make sure that the installation and operation of this product will not interfere with or compromise the operation or efficiency of any vehicle equipment!

IMPORTANT! Before returning the vehicle to active service, visually confirm the proper operation of this product, as well as all vehicle components/equipment.

Installation Guide:

Adapter Plate MBADPT14

for Harley-Davidson® Motorcycles

Internet: www.whelen.com Sales e-mail: autosale@whelen.com Canadian Sales e-mail: autocan@whelen.com Customer Service e-mail: custserv@whelen.com

Automotive: Miscellaneous