Whelen M9FCZ900 User Manual

®

ENGINEERING COMPANY INC.

51 Winthrop Road
Chester, Connecticut 06412-0684
Phone: [phone]
Fax: [phone]
Internet: www.whelen.com
Sales e-mail: [e-mail]
Canadian Sales e-mail: [e-mail]
Customer Service e-mail: [e-mail]

Installation:

1. Remove the existing 900 series lighthead and gasket
from the mounting surface.

2. Install the 2 square grommets into the Adaptor Plate
as shown.

3. Route the M9 lighthead wires through the wire
passage hole. Using the hardware provided secire the
M9 lighthead to the adaptor plate.

4. Install the 4, round hole screw grommets into the
exisiting mounting holes.

Installation Guide:

900 Series to M9 Series Scenelight

Adaptor Flange

5. Position the adaptor plate/lighthead assembly onto the
flange gasket. Make sure that this assembly is
positioned so that the gasket fits properly.

6. Place this assembly into position on the mounting
surface. Now mount the M9 flange onto the flange
gasket and secure the complete assembly to the
mounting surface using the hardware shown.

7. Extend the lighthead wires to your power source and

connect as shown in the lighthead manual.

8 X 1 PPHSMS
(4 places)

Flange Gasket

Adaptor Plate

Round Hole
Grommets

Grommet

8 X 1 3/4" PPHSMS
(2 places)

M9 Flange

Automotive: Lightheads

For warranty information regarding this product, visit www.whelen.com/warranty

©2011 Whelen Engineering Company Inc.
Form No.14517 (071811)

Page 1