Whelen M7FC700 User Manual

®

ENGINEERING COMPANY INC.

51 Winthrop Road,

Chester, Connecticut 06412-0684

Phone: [phone]

Fax: [phone]

Mounting:

1. Remove the existing 700 series lighthead and gasket from the mounting surface.

2. Mark the M7 flange mounting hole locations onto the
mounting surface by using the flange as a
template or using the measurements
shown.

3. Drill four 1/4 inch mounting
holes and insert the four
supplied #8 round hole
grommets.

#8
Grommet

Round Hole
Grommets

Mounting
Gasket

Installation Guide:

700 Series to M7 Series Flange Adapter

Model M7FC700

Internet: www.whelen.com
Sales e-mail: [e-mail]
Canadian Sales e-mail: [e-mail]
Customer Service e-mail: [e-mail]

4. Insert the two #8 square grommets into the
flange and secure the lighthead to the flange
with two #8 X 1” sheet metal screws.

NOTE: Due to the mounting hole locations
for the M Series and the variety of lighthead
styles which may be replaced, cutting or
drilling may be required for the screws
going into the square grommets.

5. Secure the Flange and lighthead to the vehicle
with the 4 supplied #8 X 1” sheet metal screws
and round grommets you installed in step 3.

6. Extend the wires to your power source and
connect as shown in the lighthead manual.

7.5"

#8 X 1 PPHSMS

Automotive: Lightheads

©2009 Whelen Engineering Company Inc.
Form No.14337 (080409)

ENGINEERING COMPANY INC.

51 Winthrop Road,

Chester, Connecticut 06412-0684

Phone: [phone]

Fax: [phone]

Mounting:

1. Remove the existing 700 series lighthead and gasket from the mounting surface.

2. Mark the M7 flange mounting hole locations onto the
mounting surface by using the flange as a
template or using the measurements
shown.

3. Drill four 1/4 inch mounting
holes and insert the four
supplied #8 round hole
grommets.

#8
Grommet

M7
Flange

M7
Gasket

For warranty information regarding this product, visit www.whelen.com/warranty

8 X 1 PPHSMS

2.5"

®

M7 Mounting Configuration

Installation Guide:

700 Series to M7 Series Flange Adapter

Model M7FC700

Internet: www.whelen.com
Sales e-mail: [e-mail]
Canadian Sales e-mail: [e-mail]
Customer Service e-mail: [e-mail]

4. Insert the two #8 square grommets into the
flange and secure the lighthead to the flange
with two #8 X 1” sheet metal screws.

Round Hole
Grommets

Mounting
Gasket

NOTE: Due to the mounting hole locations
for the M Series and the variety of lighthead
styles which may be replaced, cutting or
drilling may be required for the screws
going into the square grommets.

5. Secure the Flange and lighthead to the vehicle
with the 4 supplied #8 X 1” sheet metal screws
and round grommets you installed in step 3.

6. Extend the wires to your power source and
connect as shown in the lighthead manual.

#8 X 1 PPHSMS

Automotive: Lightheads

©2009 Whelen Engineering Company Inc.
Form No.14337 (080409)

7.5"

M7
Flange

M7
Gasket

For warranty information regarding this product, visit www.whelen.com/warranty

8 X 1 PPHSMS

Page 1

2.5"

M7 Mounting Configuration