Whelen M2PEDB User Manual

1

5

4

6

11

12

10

2

M2 series Lighthead

& Bushings

(shown for reference)

1

9

87

3

ITEM PART NUMBER DESCRIPTION

M2 PEDESTAL MOUNT KIT (BLACK)

M2 PEDESTAL MOUNT KIT (CHROME)

01-046D776-00

01-046D776-01

QTYQTY

*

*

2

3

1

1

1

1

SCREW, 1/4 -20 x 7/16 PPHMS

WASHER, .250 ID X .625 OD X .040 FLAT

HOUSING (BLACK)

HOUSING (CHROME)

WASHER, EXTERNAL TOOTH LOCK

STANDOFF, 15/32 L X 3/8 W, 1/4-20

BASE, PEDESTAL MOUNT (BLACK)

BASE, PEDESTAL MOUNT (CHROME)

SCREW, 1/4-20 X 1 1/4 PPHMS

WASHER, SPLIT-LOCK 1/4”

NUT, HEX 1/4-20

SCREW, #8 X 3/4 PPHSMS

11-487165-001

11-487165-003

16-1612420-05

20-1512120310

11-36D771-001

11-36D771-003

11

12

4

5

6

7

8

9

10

111

1

2

2

2

2

2

2

2

2

2

2

122

®

ENGINEERING COMPANY INC.

51 Winthrop Road
Chester, Connecticut 06412-0684
Phone: [phone]
Fax: [phone]
Internet: www.whelen.com
Sales e-mail: [e-mail]
Canadian Sales e-mail: [e-mail]
Customer Service e-mail: [e-mail]

Mounting

1. Position the Pedestal Mount Base (Item 7 or 8) onto
the proposed mounting surface.

NOTE! Mounting this product requires drilling through the
mounting surface. It is absolutely necessary to make sure
that no other vehicle components could be damaged by
this process.

2. Using the base as a template, mark the location of the
two mounting holes using a scribe or similar tool.

3. Remove the base and drill the two mounting holes
using a .281 drill bit. Deburr these holes before
continuing.

4. Return the base to its mounting position and secure it
using the hardware provided (Items 9, 10 & 11).

5. Locate the housing included with this kit (Item 3 or 4).
Route the wires from your M2 lighthead (sold
separately) through the housing as shown.

Installation Guide:

Pedestal Mount Kit

M2 series Lighthead

6. Secure the lighthead to the housing using the
bushings included with your lighthead and the
screws included with the pedestal mount kit (item

12). Do not
lighthead.

7. Insert the hexagonal standoff (item 6) into the
base as shown. Position the lighthead/housing
assembly onto the base and install hardware
items 1, 2 & 5.

8. Adjust the lighthead/housing assembly to the
desired angle and tighten the appropriate
hardware.

Wiring

Refer to the manual included with your lighthead for
important wiring and fusing information.

use the screws included with your

Automotive: Lightheads

For warranty information regarding this product, visit www.whelen.com/warranty

©2012 Whelen Engineering Company Inc.
Form No.14608 (071612)

Page 1