Whelen ALPHA1 User Manual

®

ENGINEERING COMPANY INC.

51 Winthrop Road
Chester, Connecticut 06412-0684

ALPHA Switches 1-4

Wiring Guide:

Phone: [phone]
Fax: [phone]
Internet: www.whelen.com
Sales e-mail: [e-mail]
Canadian Sales e-mail: [e-mail]
Customer Service e-mail: [e-mail]

DANGER! Sirens produces extremely loud emergency warning tones! Exposure to these

tones without proper and adequate hearing protection, could cause ear damage and/or hearing
loss! The Occupational Safety & Health Administration (www.osha.gov) provides information
necessary to determine safe exposure times in Occupational Noise Exposure Section 1910.95.
Until you have determined the safe exposure times for your specific application, operators and
anyone else in the immediate vicinity should be required to wear an approved hearing protection
device. FAILURE TO FOLLOW THIS RECOMMENDATION COULD CAUSE HEARING LOSS!

Safety First

This document provides all the necessary information to allow your Whelen product to be properly and safely installed.
Before beginning the installation and/or operation of your new product, the installation technician and operator must
read this manual completely. Important information is contained herein that could prevent serious injury or damage.

• Proper installation of this product requires the installer to have a good understanding of automotive electronics,
systems and procedures.

• If mounting this product requires drilling holes, the installer MUST be sure that no vehicle components or other
vital parts could be damaged by the drilling process. Check both sides of the mounting surface before drilling
begins. Also de-burr any holes and remove any metal shards or remnants. Install grommets into all wire
passage holes.

• If this manual states that this product may be mounted with suction cups, magnets, tape or Velcro®, clean the
mounting surface with a 50/50 mix of isopropyl alcohol and water and dry thoroughly.

• Do not install this product or route any wires in the deployment area of your air bag. Equipment mounted or
located in the air bag deployment area will damage or reduce the effectiveness of the air bag, or become a
projectile that could cause serious personal injury or death. Refer to your vehicle owner’s manual for the air bag
deployment area. The User/Installer assumes full responsibility to determine proper mounting location, based
on providing ultimate safety to all passengers inside the vehicle.

• For this product to operate at optimum efficiency, a good electrical connection to chassis ground must be
made. The recommended procedure requires the product ground wire to be connected directly to the NEGATIVE
(-) battery post.

• If this product uses a remote device to activate or control this product, make sure this control is located in an
area that allows both the vehicle and the control to be operated safely in any driving condition. DO NOT
ATTEMPT TO ACTIVATE OR CONTROL THIS DEVICE IN A HAZARDOUS DRIVING SITUATION.

• It is recommended that these instructions be stored in a safe place and
referred to when performing maintenance and/or reinstallation of this
product.

• FAILURE TO FOLLOW THESE SAFETY PRECAUTIONS AND
INSTRUCTIONS COULD RESULT IN DAMAGE TO THE PRODUCT OR
VEHICLE AND/OR SERIOUS INJURY TO YOU AND YOUR PASSENGERS!

ACTIVATION OF THIS
SIREN MAY DAMAGE
UNPROTECTED EARS!

CAUTION

Loud siren noise can cause
hearing damage and/or loss.

Wear

Refer to OSHA Section 1910.95 prior

Protection!

to putting ANY siren into service!

Automotive: Sirens/Switches

For warranty information regarding this product, visit www.whelen.com/warranty

©1998 Whelen Engineering Company Inc.
Form No.13106E (050608)

Page 1

WARNING!

DISCONNECTING THE VEHICLE BRAKE LAMP
CIRCUIT USING ANY SIRENS WITH RELAY OUTPUTS
OR SWITCH CONTROLLERS COULD CAUSE
VEHICLE OR PROPERTY DAMAGE, SERIOUS INJURY
OR EVEN DEATH.

DISABLING THIS CIRCUIT IS A VIOLATION OF THE
FEDERAL MOTOR VEHICLE SAFETY STANDARD
FOR THE THIRD BRAKE LIGHT, AS WELL AS REAR
BRAKE LIGHTS.

FUNCTIONS THAT BLACK OUT THE REAR BRAKE
LIGHTS (SOMETIMES CALLED “BRAKE LIGHT CUT
OUT”) MAY INTERFERE WITH THE BRAKE SHIFT
LOCK MECHANISM, AND CAUSE THE VEHICLE TO
MOVE UNEXPECTEDLY AND DANGEROUSLY.

DISCONNECTING THE BRAKE LIGHTS IN ANY WAY
IS AT YOUR OWN

RISK AND IS NOT RECOMMENDED

BY WHELEN.

Page 2

SWITCH ASSEMBLY (Alpha 1)

Connecting the GREEN wire to the wire(s) below will enable the following specific siren tones:

WHITE/BROWN = WAIL WHITE/ORANGE = Hands Free
WHITE/RED = YELP WHITE/BROWN + WHITE/RED = PIERCER

BUTT SPLICES

RED

WHT/GRN

GRN

SEE OPTION TABLE

HORN

RELAY

CUT

WIRE

GRY

WHT

ALPHA™

REMOTE

AMPLIFIER

ALL DIP

SWITCHES

DOWN

(DEFAULT)

P2-1 RED (+12V)

P2-2 WHT/GRN (H/R)

P2-3 WHT/BRN (CTRL 1)

P2-4 WHT/RED (CTRL 2)

P2-5 WHT/ORG (CTRL 3)

P2-6 WHT/YEL (CTRL 4)

P1-4 ORG

P1-3 BROWN

P1-2 BLACK

P1-1
RED

10 AMP

FUSE

BATTERY

100 WATT
SPEAKER

+

NO CONNECTION

SWITCH ASSEMBLY (Alpha 2)

Connecting the GREEN wire to the wire(s) below will enable the following specific siren tones:

WHITE/BROWN = WAIL WHITE/ORANGE = Hands-Free
WHITE/RED = YELP WHITE/BROWN + WHITE/RED = PIERCER™

A simulated Airhorn tone is always available by pressing SW2.

VEHICLE

HORN

GRN

RED

WHT/GRN

WHT

SW1

GRY

ALPHA™

REMOTE

AMPLIFIER

ALL DIP

SWITCHES

DOWN

(DEFAULT)

P2-1 RED (+12V)

P2-2 WHT/GRN (H/R)

P2-3 WHT/BRN (CTRL 1)

P2-4 WHT/RED (CTRL 2)

P2-5 WHT/ORG (CTRL 3)

P2-6 WHT/YEL (CTRL 4)

P1-4 ORG

P1-3 BROWN

P1-2 BLACK

P1-1
RED

10 AMP

FUSE

BATTERY

100 WATT
SPEAKER

+

BUTT SPLICES

SEE OPTION TABLE

RED

WHT/GRN

GRN

HORN

RELAY

Page 3

CUT

WIRE

GRY

WHT

SW2

VEHICLE

HORN

GRN

RED

WHT/GRN

WHT

SW1

GRY

SWITCH ASSEMBLY (Alpha 3)

Connecting the GREEN wire to the wire(s) below will enable the
following specific siren tones in the “TONE 1” switch position of SW1:

WHITE/BROWN = WAIL
WHITE/RED = YELP
WHITE/ORANGE = Hands-Free

BUTT SPLICES

Connecting the VIOLET wire to the wire(s) below will enable the fol­lowing specific siren tones in the “TONE 2” switch position of SW1:

WHITE/BROWN = WAIL
WHITE/RED = YELP
WHITE/ORANGE = Hands-Free

A simulated Airhorn tone is always available by pressing SW2.

RED

WHT/GRN

GRN

VIO

ALPHA™

REMOTE

AMPLIFIER

ALL DIP

SWITCHES

DOWN

(DEFAULT)

P2-1 RED (+12V)

P2-2 WHT/GRN (H/R)

P2-3 WHT/BRN (CTRL 1)

P2-4 WHT/RED (CTRL 2)

P2-5 WHT/ORG (CTRL 3)

P2-6 WHT/YEL (CTRL 4)

P1-4 ORG

P1-3 BROWN

P1-2 BLACK

P1-1
RED

10 AMP

FUSE

100 WATT
SPEAKER

+

BATTERY

HORN

RELAY

OPTION TABLE -SWITCH ASSEMBLY (Alpha 4)

Connecting the GREEN wire to the wire(s) below will enable the
following specific siren tones in the “TONE 1” switch position of SW1:

WHITE/BROWN = WAIL
WHITE/RED = YELP
WHITE/ORANGE = Hands-Free

GRN

RED

DIODE

SW2

VIO

NOTE: GRN = Control for TONE 1

SW1

VIO

VIO = Control for TONE 2

SPLICE

Connecting the VIOLET wire to the wire(s) below will enable the fol­lowing specific siren tones in the “TONE 2” switch position of SW1:

WHITE/BROWN = WAIL
WHITE/RED = YELP
WHITE/ORANGE = Hands-Free

A simulated Airhorn tone is only available when SW1 is in the ON
position. Activate via SW3.

VEHICLE

HORN

ALPHA™

REMOTE

AMPLIFIER

ALL DIP

SWITCHES

DOWN

(DEFAULT)

P2-1 RED (+12V)

P2-2 WHT/GRN (H/R)

P2-3 WHT/BRN (CTRL 1)

P2-4 WHT/RED (CTRL 2)

P2-5 WHT/ORG (CTRL 3)

P2-6 WHT/YEL (CTRL 4)

P1-4

ORG
BRN

P1-3

P1-2

BLK

P1-1

RED

10 AMP

FUSE

BATTERY

100 WATT
SPEAKER

+

BUTT SPLICES

RED

WHT/GRN

GRN

VIO

BLK

HORN

RELAY

GRN

BLK

SW3

VIO

WHT WHT

GRY

SW2 SW1

VIO

REDRED

GRY

NOTE: GRN = Control for TONE 1

VIO = Control for TONE 2

CUT

WIRE

Page 4

VEHICLE

HORN

WHT/GRN

WHT