Super Cardioid
Dynamic
Microphone
DM3.0 & DM3.0S
• Supercardioid pick up pattern to reduce feedback
• Gold plated XLR connector
• Excellent off axis rejection for superior gain before feedback
• Dent resistant spring steel grille combined with rugged zinc alloy body
• Ultra sensitive Neodymium element for high output, low distortion and
clean sound.
• Special shock-mounting allows movement of the mic element and greatly
reduces handling noise
• On/Off Switch (DM3.0S)
Applications:
Live Stage: Club, House of Worship, Gospel,
Corporate Presentation, Karaoke
Instruments: Electric guitar, snare, toms,
brass, congas, ute
Home studio: Vocal
and instrumental
applications.
The DM3.0S is available either as a single
mic, or as a pack of three microphones.
The single pack contains one microphone
with stand adaptor as well as a 4.5 meter
XLR-XLR cable. The pack of microphones
is supplied in a hard wearing carry case and
contains three microphones with stand
adaptors and screws.
The DM3.0 is a dynamic moving coil microphone designed to handle a wide
variety of vocal and instrument applications for both live sound and recording.
This microphone is also available with an integral on/off switch (DM3.0S). The
wide super cardioid polar pattern minimizes feedback problems and effectively
rejects signals not originating directly in front of the mic capsule, resulting in
a warm and natural response for nearly every type of voice. The DM3.0 and
DM3.0S are engineered to handle very high levels of gain without distortion
and will provide over 20dB of off axis feedback rejection. Low impedance and
balanced output allow interference free performance even with long cable
runs.
The DM3.0 and DM3.0S are built with a solid cast zinc alloy body, steel mesh
grille ball and internal pop screen. The special shock mounting allows movement
of the mic element and greatly reduces any handling noise.
Description
Polar Charts
Specications
Transducer Type Dynamic
Frequency Response 50Hz -18KHz
Polar Pattern Supercardioid
Output Impedance 250ohms
Sensitivity -54db (OdB=1V/Pa)
Off axis rejection >25dB at125°
Maximum SPL >135dB
Cable/Connector 3 pin gold plated
Polarity Positive voltage on
pin 2 relative to pin 3
of output XLR connector
Housing Zinc alloy
Weight 300gram
House, Sovereign Court, Ermine Business Park, Huntingdon, Cambridgeshire, PE296XU
Tel: 0845 458 0011 / +44 (0) 1480 447700 Fax: +44 (0) 1480 431767
www.wharfedalepro.com
The information in this brochure is subject to change without notice. All rights reserved © 2004 Wharfedale Pro
Wharfedale Pro is a member of the International Audio Group
WP.DM3.03.2006