Westwood Design Brookline Combo Hutch User Manual

Assembly Instructions

Brookline Combo Hutch

A. Remove the hutch from the packaging, and use the Allen wrench to remove the three screws

holding the protective board to the bottom of the hutch. You can discard this board.
B. If you are using a changing pad, secure it to the combo using the straps as instructed by the pad
manufacturer. Center the hutch on top of the combo, then screw the wood screws (A) through the
holes on the mounting plates and into the combo.
C. Insert the shelf tabs (B) into the desired holes, and carefully lower the shelves onto the tabs. Screw
the wood screws through the holes in the bottom of the shelf tabs into the bottom of the shelf to
prevent the shelf from being accidentally removed. If you are using the hutch with a changing pad,
you should remove the lower shelf and save it for later use.
D. Plug the cord for the lights into a socket behind the combo. Do not run the wire in the open where
children can access it. Turn on and dim the lights by touching the metal pad behind the right side
edge.

2 x Wood Screw

A

8 x Shelf Tab

B

Allen Wrench

C

Board (can be discarded)

Figure A

Allen Screws

Shelf Tab (B)

Wood Screw (A)

Touch Pad

Location

westwood design

W

635 N. Billy Mitchell Rd., Ste. B

Salt Lake City, UT 84116
Phone: [phone]

[e-mail]

November 19, 2007

Figure B

Figure C