West Penn CN-F11TFE Specsheet

CN-F11TFE

CN-F11TFE

RG11/U “F” PLENUM TYPE CONNECTOR

1/8” (3.2mm)

3/8” (9.5mm)

FOIL

OUTER BRAID

INNER BRAID

PIN FLUSH WITH
DIELECTRIC

FOIL

CRIMP

FLUSH WITH CONNECTOR

1/4” (6.4mm)

CRIMP

1. Slide crimp ring onto cable before beginning
installation instructions. Expose 1/8” of
center conductor (Do not score center
conductor).

2. Remove 3/8” of Jacket (Do not cut through
braid).

3. Fold outer braid back over cable jacket and
remove foil (Do not cut inner braid). Fold
outer braid back over inner braid.

QUAD SHIELDED

4. Flair braid slightly to insure proper installation
of connector. Push connector pin over cable
center conductor and crimp using a .100 Hex
crimp tool.

5. Guide pin through connector insulator while
pushing connector onto cable until a
reasonable stop is felt. Slide crimp ring
up over braid until flush with connector.

6. Crimp connector using a .384” Hexagon
crimp tool.

2833 West Chestnut Street

Washington, PA 15301

Phone [phone] • Fax [phone]

www.westpenn-wpw.com