West Penn CN-BM73-4 Specsheet
Assembly Instructions:
1. Trim Cables as shown, taking care not to nick the inner Conductor
or braid.
2. Slip crimp sleeve over cable. Place inner conductor into contact,
take care that inner dielectric is square and touching center contact.
Crimp with the appropriate Crimp tool.
3. Flair outer braid, slip the dielectric sleeve over the dielectric. Push
the contact or center pin into the connector body until a gentle
snap is felt, indicating the contact is in place. Slide the crimp sleeve
in place being sure it butts against rear of connector body. Crimp
with the appropriate tool. Crimp only
once to the back of the crimp
sleeve using the appropriate Crimp.
CN-BM73-4
CN-BM73-4
2833 West Chestnut Street
Washington, PA 15301
www.westpenn-wpw.com
e-mail: info@westpenn-wpw.com
75Ω RG6/U Plenum BNC Connector
3 piece BNC
724-222-7060
FAX: 724-222-6420
TOLL FREE: 800-245-4964
PART NO. CABLE TYPE
A
CRIMP FERRULE
HEX SIZE
B
FERRULE I.D.
C
CONNECTOR
Body I.D.
D
CONTACT I.D.
JACKET O.D. WPW CABLES
CN-BM73-4 RG6/U PLENUM .310” .365” .278” .044”
.236”
(5.99mm)
256350
25806
D
C
B
A
PART NO. CABLE
CRIMP
BRAID HEX
CRIMP TOOL STRIP TOOL
CN-BM73-4
RG6/U
PLENUM
.310” TL-107 TL-7503
Center Pin
Crimp
.068”
.63
.158
.325
CRIMP SLEEVE
CONTACT
CRIMP AREA
CRIMP AREA
Loading...