West Penn CN-BM53-26 Specsheet

Rev. 1. 5/06

Assembly Instructions:

1. Trim Cables as shown, taking care not to nick the inner Conductor
or braid.

2. Slip crimp sleeve over cable. Place inner conductor into contact,

take care that inner dielectric is square and touching center contact.
Crimp with the appropriate Crimp tool.

3. Flair outer braid, slip the dielectric sleeve over the dielectric. Push

the contact or center pin into the connector body until a gentle
snap is felt, indicating the contact is in place. Slide the crimp sleeve
in place being sure it butts against rear of connector body. Crimp
with the appropriate tool. Crimp only

once to the back of the crimp

sleeve using the appropriate Crimp.

CN-BM53-26

CN-BM53-26

2833 West Chestnut Street

Washington, PA 15301

www.westpenn-cdt.com

e-mail: [e-mail]

50Ω RG11/U BNC Connector

3 piece BNC

724-222-7060

FAX: [phone]

TOLL FREE: 800-245-4964

PA CALL: 800-222-8883

PART NO. CABLE TYPE

A

CRIMP FERRULE

HEX SIZE

B

FERRULE I.D.CCONNECTOR BODYDCONTACT I.D.

JACKET O.D. WPW CABLES

CN-BM53-26 RG11/U .445” .410” .290” .062”

.405”

(10.29mm)

1135
4811

D

C

B

A

PART NO. CABLE

CRIMP

BRAID HEX

CRIMP TOOL STRIP TOOL

CN-BM53-26 RG11/U .445” TL-113 TL-124**

Center Pin

Crimp

.068”

**- Center Conductor blade must be removed before using