West Penn CN25810KBNC Specsheet
Assembly Instructions:
1. Trim Cables as shown, taking care not to nick the inner Conductor
or braid.
2. Slip crimp sleeve over cable. Place inner conductor into contact,
take care that inner dielectric is square and touching center contact.
Crimp with the appropriate Crimp tool.
3. Flair outer braid, slip the dielectric sleeve over the dielectric. Push
the contact or center pin into the connector body until a gentle
snap is felt, indicating the contact is in place. Slide the crimp sleeve
in place being sure it butts against rear of connector body. Crimp
with the appropriate tool. Crimp only
oonnccee
to the back of the crimp
sleeve using the appropriate Crimp.
CN25810KBNC
CN25810KBNC
2833 West Chestnut Street
Washington, PA 15301
www.westpenn-wpw.com
e-mail: info@westpenn-wpw.com
50Ω RG8/U Plenum
3 Piece BNC- 50Ω Connector
724-222-7060
FAX: 724-222-6420
TOLL FREE: 800-245-4964
PP AA RRTT NNOO.. CCAABB LL EE TTYYPPEE
AA
CCRRII MMPP FFEERRRRUULLEE
HHEEXX SSII ZZEE
BB
FFEERRRRUULLEE II..DD..
CC
CCOONNNNEECCTTOORR BB OODDYY
II..DD..
DD
CCOO NNTTAACCTT II..DD ..
JJAACCKKEETT OO..DD.. WW PPWW CCAABBLLEESS
CCNN2255881100KKBB NNCC RR GG88 //UU PP LL EE NNUUMM .. 3388 44”” .. 4400 55”” .. 2299 55”” .. 0099 55”” .. 3355 22”” 22 55881100
D
C
B
A
PP AA RRTT NNOO.. CCAABB LL EE
CCRRII MMPP
BBRR AAIIDD HHEEXX
CCRRIIMMPP TTOO OOLL SSTT RR II PP TTOOOOLL
CCNN2255881100KKBB NNCC
RR GG 88//UU
PP LLEE NNUUMM
.. 33 8844 ”” TTLL--111155 TTLL--112244 ****
CCeenntteerr PPiinn
CCrriimmpp
.. 11 0000 ””
.545”
.335”
.200”
Crimp Sleeve
Contact
Crimp Area
Crimp Area
** Stipping Tool Adjustments
1. Back off center conductor blade adjustment
(This will turn TL-124 into a two step stripper).
2. Tighten down middle blade adjustment so that
it will cut cable down to conductor.
3. Slight adjustment of third blade may be needed
to cut overall cable jacket properly.
4. After stripping - cut conductor to .200” to
allow contact pin to fit snug against
insulation.
Loading...