West Penn AV-IP-KIT-NA User Manual
Product Guide
AV-IP System & Components
Cost-Eective AV Distribution Systems for
Classrooms and Boardrooms
www.westpennwire.com
We’re at the Intersection of AV and IT
AV over IP (AV-IP) is the transmission of audio-visual data over an Internet, LAN or WAN network. It’s replacing traditional
circuit-based AV infrastructures with packet-based Internet-Protocol or IP-based streaming infrastructures, while
preserving the very best image and sound quality over greater distances.
West Penn Wire offers cost-effective solutions to support the migration to AV-IP, creating the setting for greater
innovation and collaboration. Whether it’s the boardroom or the classroom, West Penn Wire’s AV-IP system and
components are providing maximum value to users and their audio and video assets.
Our system is AV-IP for point-to-point in-room AV distribution or can be expanded for AV collaboration, producing a
bandwidth-controlled environment, higher resolutions and frame rates, and very low latency.
> Provides HDMI (1080P), VGA with audio and USB from a source or multiple sources to a display location
via Category 6 UTP cabling.
> Allows an installer to cable with Category 6 UTP cabling to each device. This is an inexpensive solution
over HDBaseT shielded cabling.
> Inputs and audio can be managed by our 8-button controller.
> All components – TX, RX and controller – share a 1G PoE switch. The PoE switch consolidates all
West Penn Wire devices into a simplistic power design.
> Supports control of AV signaling.
> All users – from educators to executives – can quickly select the input and manipulate the audio.
This is a user-experience advantage over a hardwired rapid-run solution.
To Network Managed Switch
Category 6 UTP Cables (4246 / 254246)
HDMI Assemblies
Audio Distribution
HDMI Assemblies
www.westpennwire.com
AV-IP Transmitter
AV-IP-WP772-WH
Overview:
The HDMI/VGA/USB IP Wall Plate Transmitter installs in a double-gang
wall box to provide a convenient interface for HDMI / VGA input sources
to be extended to one or more displays, and USB 2.0 connectivity to
manage Smart White Boards and other USB-based devices. The unit has
one HDMI-In, one VGA-In with Audio-In, one USB Type B port, and one
Ethernet port. It supports video up to 3840x2160 @ 30Hz, and VGA up to
1920x1200 @ 60Hz. The HDMI/VGA/USB IP Wall Plate Transmitter allows
HDMI, VGA and USB equipment to be extended up to 330ft (100m). The
unit supports a push button switch and auto switching to select between
the HDMI and VGA inputs. The device may be powered via a PoE enabled
1Gigabit Ethernet Switch.
Key Features:
> Extend HDMI, VGA with 2CH audio, and USB 2.0 up to 330ft (100m)
over Cat5e/6 cable
> Supports HDMI video up to 4K (3840x2160) @ 30Hz
> Supports VGA video up to 1920x1200
> Selectable HDMI / VGA with audio inputs and auto-switching capability
> Supports point-to-point, point-to-multipoint and multipoint-to-multipoint applications
> Supports 100s of devices depending on network bandwidth
> PoE powered
> Controllable via IP Device Controller (AV-IP-NC811)
Applications:
> Commercial and residential AV systems
> K-6 and K-12 classroom AV systems
> Digital signage
> Boardroom systems
> Collaborative PC systems
> Medical information systems
www.westpennwire.com
AV-IP Receiver
AV-IP-RX776
Overview:
The HDMI/USB IP Receiver is able to receive AV signals
transmitted by the HDMI/VGA/USB IP Wall Plate Transmitter
(Model: AV-IP-WP772) over an IP network, and allows HDMI
displays and USB devices such as Smart White Boards to be
extended up to 330ft (100m). The unit has one HDMI-Out,
two USB 2.0 Type A ports, two USB 1.1 Type A ports, one
Audio-Out port, one Mic-In port, and one Ethernet port.
It supports HDMI up to 1920x1080 @ 60Hz. The device
supports PoE and may be powered via a PoE enabled
1Gigabit Ethernet Switch.
Key Features:
Extend HDMI and USB 2.0 up to 330ft (100m) over Cat5e/6 cable
> Compatible with AV-IP-WP772 Wall Plate Transmitter
> Supports HDMI video up to 1080p @ 60Hz
> Supports two (2) USB 2.0 & two (2) USB 1.1 Type A ports
> Supports an Audio-Out (for audio extract) and Mic-In port
> Supports point-to-point, point-to-multipoint and multipoint-to-multipoint applications
> Supports 100s of devices depending on network bandwidth
> PoE powered
> Controllable via IP Device Controller (AV-IP-NC811)
Applications:
> Commercial and residential AV systems
> K-6 and K-12 classroom AV systems
> Digital signage
> Boardroom systems
> Collaborative PC systems
> Medical information systems
www.westpennwire.com
Loading...