Westerbeke 4.5 BCGB-614, 3.8 BCGB-514 Specifications

Page 1
GASOLINE GENERATOR
WESTERBEKE
GASOLINE
GENERATOR
WESTERBEKE
Engines & Generators
W
TMTM
The truly “quiet breed” of reliable power ...
4.5 BCGB Marine Gasoline Generator
4.5 BCGB60Hz
3.8 BCGB50Hz
4.5 BCGB60Hz
3.8 BCGB50Hz
W
4.5 BCGB Marine Gasoline Generator
Optional Spare Parts Kit
Kit contents, as shown, may not correspond to the generator pictured.
Smooth, Quiet and Compact
Designed by Westerbeke, the Company that pioneered the truly “quiet breed” of generators, the 3­cylinder, 4.5BCGB is flawlessly smooth, quiet and compact. The engine incorporates a tuned air intake silencer and a balance shaft to diminish noise and vibration. Quieter than 3600-rpm generators, there is no other 1800-rpm gasoline generator in its size and power rating! This state-of-the-art generator will provide all your shipboard power requirements with the “quiet” that only an 1800-rpm gasoline generator can provide.
Easy Operation and Maintenance
To minimize engine maintenance, the 4.5BCGB is fresh water cooled and equipped with a simple control system without complex, troublesome, electronic components. Easy access to all servicing points (single-side servicing) allows easy installation and routine maintenance.
Powerful and Reliable
The 4.5BCGB is powered by and industrial .66 liter engine that provides a full 4.5 kilowatts at 60 Hertz or
3.8 kilowatts at 50 Hertz. The 4.5BCGB belongs to a long line of Westerbeke generators that have been the pride of many powerboat owners for their reliability.
Five Year Limited Warranty
The 4.5BCGB is backed by Westerbeke’s 5-year limited warranty. The presence of Westerbeke in over 65 countries around the world provides customers with easy access to parts, service and technical support worldwide. Established in 1937, Westerbeke is committed to providing its customers with quality products and unequaled after sales support.
Standard Features
Simple start/stop with running hour meter
Overspeed protection
Safety shut-downs — high coolant temperature, low oil pressure, high exhaust temperature
A.C. circuit breaker
Battery charger
Fresh water cooling and coolant recovery tank
90° water injected elbow
Belt-driven, raw water pump
Vibration mounts
Lube oil drain hose and drip tray
Belt guard
Operators’ manual and parts list
“CE” mark
CARB certified
EPA certified
Meets U.S.C.G. regulation 33CFR-183
Page 2
Basic Dimensions
Generator Design
DESIGN: Brushless, four pole, revolving field, power takeoff TEMPERATURE RISE: Within NEMA MG1-22.40 operating at full load. VOLTAGE REGULATION: Standard +/- 5% no load to full load. COOLING: Cast centrifugal blower, direct connected. FREQUENCY REGULATION: 3 Hz (5%) no load to full load. ELECTROMAGNETIC INTERFERENCE LEVEL: Exceeds requirements INSULATION: Class “F”, as defined by NEMA MG1-1.66. for most marine radio-telephones and standard TV’s
4.5 BCGB60Hz
3.8 BCGB50Hz
Number of cylinders 3 Cylinder, vertical in-line Type 4 cycle Displacement 40.3 cu. in. (.66 liter) Bore and stroke 2.56” x 2.61” (65.0mm x 66.3mm) Compression ratio 9.8:1 Rated rpm 60 Hz – 1800 rpm
50 Hz – 1500 rpm
HP @ 3600 rpm 11.3 HP Maximum angle of operation Not to exceed 25° in all directions
Exhaust elbow conn. 2.0” OD (50.8mm) Raw water conn. 0.75” OD (19.05mm) Dry weight 307 lbs (139.3 kg)
Combustion system Semi-spherical type Aspiration Naturally aspirated Lubrication system Forced pump Cooling system 3.5 quarts (3.4 liter)
Full load fuel consumption .63 GPH (2.4 LPH) (approx.) Carburetor Down draft type Governor Mechanical
Lube oil filter Full flow, spin on element Lubricant capacity 2.5 quarts (2.4 liters)
Fuel transfer pump Electric type Fuel supply piping .25” ID (6.35mm)
Starting motor 12 volt, 1.2 kw Battery charging 17 amps, integral electric type
Cold cranking amps 120 amps @ 70 degrees F Electrical system 12 volts DC, negative ground
Remote start-stop panel Ship-shore switch Hydro-hush muffler and fittings “A” on-board spare parts kits; “B” extended cruising spare parts kit Anti-siphon valve for overboard cooling water discharge
Technical Manual
Electrical Characteristics Ratings Engine
Model Volts Amps Hertz Phase Wire
Power Factor
KW RPM Start
4.5 BCGB-614* 120 37.5 60 1 4 1.0 4.5 1800 Remote
3.8 BCGB-514* 230 16.5 50 1 4 1.0 3.5 1500 Remote
Cylinder head Aluminum Cylinder block Cast Iron Crankshaft Forged crankshaft, four main bearings Valves Overhead, rotating type Fuel System Carbureted w/U.S.C.G. approved flame arrestor
Cooling system Fresh water-cooled with heat exchanger Exhaust manifold Cast aluminum, fresh water-cooled
inches
(millimeters)
Drawings are for reference only and should not be used for installation. Detailed installation drawings are available upon request.
*Generator field adjustable to 50 or 60 Hertz.
Distributor/Dealer
Power takeoff adapter
Construction – Engine Components
Optional Equipment
Specifications
Westerbeke Corp., Myles Standish Industrial Park, 150 John Hancock Road, Taunton, MA 02780-7319, U.S.A.• TELEPHONE : (508) 823-7677 •FAX: (508) 884-9688 •Website: www.westerbeke.com
Specifications Subject to Change without Notice.
DPS 3M 9/00
WW
WESTERBEKWESTERBEKEE
Engines & Generators
TMTM
Loading...