West Elm Wood Rod Assembly Instruction

: wood rod (thin and 2”)

mounting instructions

NOTE:

• Stud mounting is recommended. Use proper hardware for your wall type (such as anchors for drywall). When
in doubt, consult your local hardware store.

or

1x for 4’ and 6’ rod , 2x for 8’ rod

rod

screw

6x for 4’ rod , 9x for 6’ and 8’ rod

finials 2x

anchor

6x for 4’ rod , 9x for 6’ and 8’ rod

mounting bracket

2x for 4’ rod , 3x for 6‘ and 8’ rod

back plate

2x for 4’ rod, 3x for 6‘ and 8’ rod

Mounting Instructions:

1. Determine the location of the brackets on the wall. Using a pencil, mark the location of the screw holes. This is where
the hardware will be inserted. Remove from wall.

2. Mount rod onto the wall following instructions for your wall type:

Dry Wall Mounting:

- Use a Phillips screwdriver to insert the wall anchors. Do not “push” or drive the anchor into the wall, it is designed to
bore into the wall like a drill bit. Slowly turn the anchor clockwise while applying pressure until the flange just touches
the wall.

- Insert screw into the anchor turning clockwise so the bracket is snug against the wall.

Stud Mounting:

- Using a Phillips screwdriver (or drill) insert metal screws into the stud tightening in a clockwise direction so the bracket
fits snugly against the wall.

3. Place rings (sold separately) onto rod and then set the rod onto mounted brackets.

4. Attach finials.

4’ rod

or

6’ rod

8’ rod

CARE INSTRUCTIONS:

• Wipe with a soft, dry or slightly damp cloth. To protect the finish, do not apply household cleaners or
abrasives.

9204868/9204884/9204900/9204850/9204876/9204892/9237520/9237421/9237330/9237470/9237371/9237181 - 01/07

page 1 of 1