West Elm Wave Shelf Assembly Instruction
: wave shelf
mounting instructions
NOTE:
• Stud mounting is recommended. Use proper hardware
for your wall type (such as anchors for drywall). When
in doub
sa
• This shelf can be mounted either way horizontally.
• Designed to be used for decorative items only.
•
Maximum load per shelf is: 24 lbs.
Wipe with a soft, dry cloth. To protect the finish, avoid
•
the use of all chemicals and household cleaner
t, consult your local hardware store. For your
fety, installation by two people is recommended.
s.
1
2 2
2
A
B
A
drywall anchor 6x
B
screw 6x
2
! For drywall mounting, use anchors with screws.
For stud mounting, use screws only.
3-5
6
1. Hold shelf at desired location. With a pencil, mark on wall the top
outside
the loc
2.
Measure down from the top of the shelf to the top of the keyhole
no
keyhole no
ma
i
a ca
3.
For stud mounting: skip to step 4. For drywall mounting: using a
Philip's head screwdriver, insert the drywall anchors (A) into the
wall at the insertion points. Press and turn clockwise until anchors
a
4.
Insert screws (B) into the anchors or at the insertion points, l eaving
app
5.
Align keyhole notches over the screw heads.
6. Slide the shelf d
sc
corners of the shelf. These marks will be used to determine
ation of the mounting hardware.
tches. Measure in from the side of the shelf to the top of the
tches. Record these measurements on the wall, using the
rks in step 1 as a guide. Align the two measurements until they
ntersect. This is the insertion point of the mounting hardware. Use
rpenter's level to ensure the shelf will be level.
re flush with the wall.
roximately 1/2" between the back of the screw head and the wall.
own until it rests on the screws. Tighten or loosen
rews as needed to fit the shelf snugly against the wall.
8385056- 08/05 page 1 of 1
Loading...