teak bath tower short
! Tools supplied:
! Do not throw away packaging materials until assembly is complete.
! Assemble this item on a soft surface, such as cardboard or carpet, to protect fi nish.
! Proper assembly of this item requires 2 people.
assembly instructions
Hardware
AB
bolt : 6mm x 35mm 4x
bolt : 6mm x 50mm 8x
Parts
C
top 1x
E
D
leg 4x
shelf 2x
Page 1 of 3 5568845 - 03.05.08
teak bath tower short
assembly instructions
1. Position the top (C) as shown, insert the 2 legs (D) into the opening located at each corner of the top
(C). Once the leg is fully inserted, apply bolt (A) into the center hole of the top bracing as shown.
Tighten fully using the enclosed allen key.
Allen
key
C
A
D
2. Insert the 2 shelves (E) into the opening between the two previously-installed legs and align the
holes from the leg with the corresponding holes on the center of the shelf bracing (located on each
corner). Apply bolt (B) into the center hole of the shelf bracing as shown. Tighten fully using the
enclosed Allen key.
E
E
Allen
key
B
Page 2 of 3 5568845 - 03.05.08
teak bath tower short
assembly instructions
3. Insert the remaining legs (D) into the opening located at each corner of the top (C). Once the leg is
fully inserted, apply bolt (A) into the center hole of the top bracing as shown. Tighten fully using the
enclosed allen key. Align the holes from the leg with the corresponding holes on the center of the shelf
bracing (located on each corner). Apply bolt (B) into the center hole of the shelf bracing as shown.
Tighten fully using the enclosed allen key. Stand tower upright.
A
Allen key
B
Allen key
D
CARE INSTRUCTIONS
Hardware may loosen overtime. Periodically check that all connections are tight.
Wipe with a soft, dry cloth. To protect nish, avoid the use of chemicals and household cleaners.
Page 3 of 3 5568845 - 03.05.08
Loading...