West Elm Teak Bath Sconce Double Assembly Instruction
teak bath sconce double
Important Safety Instructions:
·Stud mounting is recommended. Use proper hardware for your wall type. When in doubt consult your local hardware
store. For your safety, it is strongly recommended that two people hang the lamp.
·Electric bulb should be centered inside the pendant shade, making sure it does not touch the outer sides.
·These instructions are provided for your safety. It is important that they are read carefully and completely before
assembling xture.
·This xture has been rated for up to 2 x 60-watt TYPE B bulbs (not included). To avoid the risk of re, do not exceed the
recommended wattage.
Warning:
·To reduce the risk of re, electrical shock or personal injury, always turn o
and unplug lamp and allow it to cool prior to replacing light bulb.
·Do not touch bulb when xture is turned on. Do not look directly at lit bulb.
·Keep ammable materials away from lit bulb.
Pre-assembly:
·Remove all parts and hardware from box along with any plastic protective packaging.
·Do not discard any contents until after assembly is complete to avoid accidentally discarding small parts or hardware.
·For your safety and convenience, assembly by two people is recommended
assembly instructions
A
wire caps 3x
Parts Enclosed:
• (1) Mounting plate (L)
• (1) Canopy (J)
• (1) Lamp Socket (I)
• (1) Socket Ring (F)
• (1) Glass Shade(H)
B
grounding screw
2x
Hardware Included:
• (1) Mounting screws (C)
• (2) Green ground screws (B)
• (3) Plastic wire caps (A)
• (4) Canopy screws ( D )
C
mounting screws 1x
D
canopy screws
4x
To install you will need:
• Electrical tape
• Screwdriver
F
D
L
A
H
5626213 - 03/08
B
I
J
C
page 1 of 2
teak bath sconce double
To Assemble:
1. SHUT OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN FUSE BOX/CIRCUIT BREAKER.
2. Carefully unpack all xture parts and hardware and lay out on a clear workspace.
3. Carefully inspect the chandelier's xture wires. The NEUTRAL FIXTURE WIRE is white or marked “N”. The HOT
FIXTURE WIRE is black or marked “L”. The yellow-green or bare wire is the GROUND WIRE.
4. Attach the GROUND WIRE from the xture to the GROUND JUNCTION BOX WIRE from the outlet (usually green or
bare wire). Fasten each together with a plastic wire connector (A) and wrap the connection with electrical tape. Be
sure that no wire strands are exposed. If your outlet box DOES NOT have a GROUND WIRE, be sure to insert the
green ground screw (B) into the mounting plate (L) facing DOWN, and wrap the xture's bare ground wire around
the ground screw. IT IS IMPERATIVE THAT THE OUTLET BOX IN YOUR HOME BE PROPERLY GROUNDED.
5. Connect the NEUTRAL FIXTURE WIRE to the NEUTRAL JUNCTION BOX WIRE (white). Fasten each together with a
plastic wire connector (A) and wrap the connection with electrical tape. Be sure no wire strands are exposed.
6. Connect the HOT FIXTURE WIRE to the HOT JUNCTION BOX WIRE (black). Fasten each together with a plastic wire
connector (A) and wrap the connection with electrical tape. Be sure no wire strands are exposed. DO NOT REVERSE
THE HOT AND NEUTRAL CONNECTIONS OR SAFETY WILL BE COMPROMISED.
7. Gently tuck the wire connections neatly into the ceiling junction box.
8. Attach the mounting plate (L) to the ceiling outlet box using the enclosed mounting screws (C). Tighten screws
with a screwdriver.
9. Pull canopy (J) up over the mounting plate (L), align the hole in the mounting plate with the hole in the canopy.
10. Insert the canopy screw (D) tighten with a screwdriver.
11. Unscrew sockets ring (F) from the socket.
12. Place glass shade (H) on socket (I).
13. Place the metal ring (G) onto the socket (I).
14. Screw on the socket rings (F) and tighten with wrench.
assembly instructions
Completing the Assembly:
1. Insert 2 x 60-watt Type B bulbs (not included) into the socket . DO NOT EXCEED SPECIFIED WATTAGE.
2. Restore power to junction box and test xture.
3. Assembly is complete.
Care Instructions:
• Wipe clean using a soft, dry cloth or static duster.
• Always avoid the use of harsh chemicals and abrasives to clean xture as they may damage the nish.
5626213 - 03/08
page 2 of 2
Loading...