West Elm Teak bath faucet Assembly Instruction

Single Hole Lavatory Faucet

! Professional installation required.

! Do not throw away packaging materials until assembly is complete.

! Please read all instructions carefully and completely before installation.

! Remove all parts and hardware from box and lay out on a clear work surface for easy identification.

Hardware

NO. DESCRIPTION QTY

1 ELDNAH 1

2 SET SCREW 1

3 ALLEN WRENCH 1

4 CARTRIDGE COVER 1

5 CARTRIDGE NUT 1

6 CARTRIDGE 1

7 FAUCET BODY 1

assembly instructions

8 AREATOR 1

11 RUBBER WASHER 1

13 LOCK NUT 1

14 PRESS STYLE DRAIN BODY 1

15 DRAIN TUBE 1

2 ESOH 9

1 GNIR-O 01

1 REHSAW 21

Page 1 of 37627375 - 10.22.08

Single Hole Lavatory Faucet

assembly instructions

1. Be sure water supply lines are turned to the off position. If applicable, remove existing faucet.

2. Clean surface of lavatory sink before installing new faucet.

3. Make sure drain in closed or blocked so that small parts do not fall into drain.

4. Install new faucet body assembly into the hole of the sink. Tighten mounting nut from underneath sink. Connect water supply line
to faucet.

5. Remove the aerator from faucet before using for the first time. Allow both hot and cold water to run for one minute. Replace aerator.

6. Use teflon tape to connect drain body to tube.

7. Install drain of sink.

Page 2 of 37627375 - 10.22.08