sliding door media stand
assembly instructions
! Tools required:
! Do not throw away packaging materials until assembly is complete.
! Assemble this item on a soft surface, such as cardboard or carpet, to protect fi nish.
! Proper assembly of this item requires 2 people.
Hardware
AB
cam bolt 12x Cam lock12x
CD
dowel 12x shelf support 8x
E
short screw 18x
Page 1 of 55946165/5946173 - 03.03.08
sliding door media stand
assembly instructions
1. Lay the bottom of the media stand on a soft surface. Insert 6 dowels (C) into holes as drawing shows.
Using a phillips head screwdriver screw the cam bolts (A) into the bottom panel. Insert cam locks (B)
into the end panels and the partition like the drawing shows. Slide the end panels and partitions
down over the dowels and cam bolts. Tighten cam locks with phillips head screwdriver.
End panel
Partition
End panel
A
C
2. Insert 6 dowels (C) into holes in the bottom of the top panel. Using a phillips head screwdriver screw
the cam bolts (A) into the bottom of the top panel. Insert cam locks (B) into the end panels and the
partition like the drawing shows. Assemble the top panel down onto the end panels and partition
aligning the dowels and cam bolts. Tighten cam locks (B) with a phillips head screwdriver.
B
Top panel
Top panel
A
C
B
Page 2 of 55946165/5946173 - 03.03.08
sliding door media stand
assembly instructions
3. Center back screen onto back of media stand and screw in 18 screws (E) through back screen into media
unit using a phillips head screwdriver.
4. Insert 8 shelf support (D) into end panels and partition to support the shelves. Make sure that the
supports are level and that the shelf sits at.
Page 3 of 55946165/5946173 - 03.03.08
sliding door media stand
assembly instructions
5. Align bottom of sliding door into track in bottom panel, making sure that the top door lock is down.
Stand door upright against the top panel. Slide door lock up making sure that it latches into the groove
in the bottom of the top panel.
Slide door into place at angle, aligning bottom guide into track
Then stand the door up
into place
Top lock in down position
Door locks
Top lock in up (Locked) position
Track in bottom panel
Page 4 of 55946165/5946173 - 03.03.08
sliding door media stand
assembly instructions
!
CAUTION
The top shelf of this stand is intended for use with:
Plasma/LCD Televisions having a maximum screen size of 52” and a weight of 135 lbs.
Tube televisions having a maximum screen size of 30” and weight of 135 lbs.
CARE INSTRUCTIONS
Hardware may loosen overtime. Periodically check that all connections are tight.
Wipe with a soft, dry cloth. To protect nish, avoid the use of chemicals and household cleaners.
Page 5 of 55946165/5946173 - 03.03.08
Loading...