West Elm Rolling Storage 4 Cube Media Assembly Instruction

rolling storage media 4 cube
! Tools Required: ! Do not throw away packaging materials until assembly is complete. ! Assemble this item on a soft surface, such as: cardboard or carpet to protect fi nish. ! Proper assembly of this item requires 2 people.
assembly instructions
A
B
C
D
bolt 5/16” dia. x 3” 6x
metal washer 6x
lock washer 6x
E
F
G
snap-lock 5x
screw 5/16” dia. x 1” 16x
magic wire 4x
???????-08.05.09
allen key 1x
Page 1 of 3
rolling storage media 4 cube
assembly instructions
1. Attach the bottom panel to the side panels and the partitions with bolts (A), metal washers (B), and lock washers (C). Tighten with allen key (D).
side panel
partition
bottom panel
C
side panel
B
A
D
6x
2. Attach the casters to the bottom panel with screws (F). Tighten with a phillips head screwdriver.
with lock
F
???????-08.05.09
5x
without lock
Page 2 of 3
rolling storage 3x1
assembly instructions
3. Rotate the storage unit to its upright position. Using a phillips head screwdriver, screw snap-locks(E) into the holes on the top of the side panels. Align the holes on the top panel with the snap-locks on the top of the side panels. Firmly press down until top panel snaps into place.
5x
E
4. Insert magic wire (G) into the holes of the side panel and the partition. Then place the shelves into the cabinet aligning the grooves on each ends of the shelves with the magic wire.
CARE INSTRUCTIONS Hardware may loosen over time. Periodically check that all connections are tight. Wipe with a soft, dry cloth. To protect  nish, avoid the use of chemicals and household cleaners.
???????-08.05.09
Page 3 of 3
Loading...