West Elm Parsons Door Unit Assembly Instruction

! Tools required: ! Do not throw away packaging materials until assembly is complete. ! Assemble this item on a soft surface, such as cardboard or carpet, to protect fi nish. ! Proper assembly of this item requires 2 people.
parsons door unit
assembly instructions
Hardware
A
C
E
lock washer 12x
screw 4x
B
D
F
Anti tip kit 1x
at washer 12x
plastic clasp 4x
shelf pin 8x
Mounting Plate 2x
Nylon Strap 1x
Small Screw 2x Large Screw 2x
Page 1 of 79285255 - 01/02/09
parsons door unit
assembly instructions
1. Align bottom with sides . Insert bolt (A), lock washer (C), and  at washer (B). Tighten with supplied hex key. Do not overtighten.
Page 2 of 79285255 - 01/02/09
parsons door unit
assembly instructions
2. Align Legs with bottom. Insert bolt (A), lock washer (C), and  at washer (B). Tighten with supplied hex key. Do not overtighten.
Page 3 of 79285255 - 01/02/09
parsons door unit
assembly instructions
3. Stand unit upright. Slide back panel into groove in sides.
4. Align top with sides . Insert bolt (A), lock washer (C), and  at washer (B). Tighten with supplied hex key. Do not overtighten.
Page 4 of 79285255 - 01/02/09
parsons door unit
assembly instructions
5. Press plastic clasps into grooves on back of unit like drawing shows. Insert screws into claps. Tighten with screwdriver.
D
E
Page 5 of 79285255 - 01/02/09
parsons door unit
assembly instructions
6. Align door with hinges on side . Slide door onto hinges. Making sure they snap into place.
7. Insert shelf pins into sides at desired locations. Carefully slide shelves into unit. Make sure pins are  rmly pressed into place.
Page 6 of 79285255 - 01/02/09
parsons door unit
assembly instructions
NOTICE: To prevent injury and property damage from unexpected tipping of furniture, we highly recommend installation of the anti-tip kit included with this product.
Attaching unit to wall with anti-tip kits.
1. Determine where the unit is to be placed and mark location on the wall for the mounting bracket screw holes. They should be placed approximatly 1” below the top on the back of the unit.
2. Attach the mounting bracket vertically to the wall by inserting the long screws provided through the holes in the bracket and tightening securely using screwdriver. Screws must penetrate wall studs for proper installation.
3. Next using the short screws attach the 2nd bracket to the back of the unit top.
4. Lace the nylon strap down through the brackets. Slide the thin end of the strap through the receiving end of the nylon strap. Pull to tighten tower snug against wall.
Long Screw
Short Screw
Adjustable levelers are installed in the legs to accommodate uneven  ooring. To adjust these levelers,
CARE INSTRUCTIONS Hardware may loosen overtime. Periodically check that all connections are tight. Wipe with a soft, dry cloth. To protect  nish, avoid the use of chemicals and household cleaners.
simply turn them counterclosckwise to raise the leg.
Page 7 of 79285255 - 01/02/09
Loading...