sawhorse work table
assembly instructions
! Tools required:
! Do not throw away packaging materials until assembly is complete.
! Assemble this item on a soft surface, such as cardboard or carpet, to protect fi nish.
! Proper assembly of this item requires 2 people.
(Supplied)
Parts
AB
sawhorse end 4x
C
cross brace 4x
Hardware
D
glass top 1x
rubber glass bumpers 4x
E
bolt 8x
Page 1 of 35626437/5632567 - 02.26.08
sawhorse work table
assembly instructions
1. Stand 1 sawhorse end (A) upright and align one center brace (B) by the holes in the end. Insert 1
bolt (E) thru the sawhorse end (A) into the center brace (B) and tighten with supplied allen key.
Repeat on other end of center brace (B).
Repeat step at bottom of sawhorse end (A)
DO THIS STEP TWICE TO CREATE 2 COMPLETE SAWHORSES
E
B
E
A
E
2. Align 2 rubber glass bumpers (D) with the holes in the top of the sawhorses (A) and press rmly into
place. Repeat for both sawhorses (A)
D
B
A
E
D
Page 2 of 35626437/5632567 - 02.26.08
3. THIS STEP REQUIRES AT LEAST 2 PEOPLE
Carefully lay glass top (C) on top of metal sawhorses.
C
sawhorse work table
assembly instructions
Glass top alignment stickers
NOTE:
Align metal sawhorse bases with
the stickers on the glass top.
4. Sawhorse ends must be no more than 12” from end of glass.
12”
304.8mm
CARE INSTRUCTIONS
Hardware may loosen overtime. Periodically check that all connections are tight.
wipe with a soft, dry cloth. To protect nish, avoid the use of chemicals and household cleaners.
12”
304.8mm
Page 3 of 35626437/5632567 - 02.26.08
Loading...