West Elm Metal Picture Ledge Assembly Instruction

: metal picture ledge
mounting instructions
NOTE:
• Stud mounting is recommended. Use proper hardware for your wall type (such as anchors for drywall). When in doubt, consult your local hardware store. For your safety, installation by two people is recommended.
• Wipe with a soft, dry cloth. To protect the finish, avoid the use of all chemicals and household cleaners.
• Maximum load for 2’ shelf : 20 lbs.
• Maximum load for 3’ and 4’ shelves : 40 lbs.
A
B
A
drywall anchor 2x - 2’
3x - 3’ and 4’
B
screw 2x - 2’
3x - 3’ and 4’
! For drywall mounting, use anchors with screws.
For stud mounting, use screws only.
1. Hold shelf at desired location. Use a carpenter's level to ensure the shelf will be level. With a pencil, mark through the top of the mounting holes. These marks are the insertion points of the mounting hardware.
2. For stud mounting: skip to step 3. For drywall mounting: using a Phillips head screwdriver, insert the drywall anchors (A) into the wall at the insertion points. Press and turn clockwise until anchors are flush with the wall.
3. Insert screws (B) into the anchors or at the insertion points, leaving approximately 1/2" between the back of the screw head and the wall.
4. Align keyhole notches over the screw heads.
5. Slide the shelf down until it rests on the screws. Tighten or loosen screws as needed to fit the shelf snugly against the wall.
9775941/9775958/9775966- 09/07
page 1 of 1
Loading...