West Elm Flip Door Media Unit Assembly Instruction

! Tools supplied:
! Do not throw away packaging materials until assembly is complete. ! Assemble this item on a soft surface, such as cardboard or carpet, to protect fi nish.
! Proper assembly of this item requires 2 people.
Hardware
ip door media unit
assembly instructions
A
C
E
G
lock washer 8x
com lock 10x
B
at washer 8x
D
cam bolt 10x
F
shelf pin 12x
H
screw 6x
Mounting Plate 4x
plastic clasp 6x
Anti tip kit 2x
Nylon Strap 2x
Small Screw 4x Large Screw 4x
Page 1 of 79509415 - 12/30/08
ip door media unit
assembly instructions
1. Align the end panels and partitions with the bottom frame as the drawing shows. Be sure the holes on the sides of the panels are facing toward the center of the case. Secure the end panels firmly by inserting bolt (A), flat washer (B) and lock washer (C). Attach the partitions in same manner but do not tighten completely. Screw in the cam bolts (D) at the top of the partitions. Insert cam locks into back of front rail. Align front rail with the cam bolts and press firmly into place. Turn cam locks clockwise to lock rail into place. Finish tightening bolt, flat washer and lock washer in bottom of partitions.
D
C
B
A
2. Slide back panel down into grooves in back of end panels as shown.
E Holes at top face inward
Partition
End Panel
Page 2 of 79509415 - 12/30/08
ip door media unit
assembly instructions
3. Align the doors with the holes in the bottom panel, making sure the door pulls are at the top outside of the doors as the drawing shows.
Page 3 of 79509415 - 12/30/08
Loading...
+ 4 hidden pages