West Elm Bracket Squares Assembly Instruction

: bracket square s/2

mounting instructions

NOTE:

• Stud mounting is required. Use proper hardware
for your wall type. When in doubt, consult your
local hardware store. For your safety, installation
by two people is recommended.

• MOUNTING LOAD CAPACITY IS 75 LBS.

• Wipe with a soft, dry cloth. To protect the nish, avoid
the use of all chemicals and household cleaners.

1. Use a stud nder to locate the studs in your wall and mark these locations in the desired mounting area of the wall.
Use a carpenter’s level to insure the shelf will be level. Hold the brackets at desired locations and mark through the holes
with a pencil onto the wall. Be sure that one screw for each bracket will to go into a stud. The other screw for each
bracket will be used with the drywall anchor.

A

drywall anchor 2x

B

screw 4x

2. For drywall mounting, drill a 3/16" hole in the wall at the pencil marks that are not in line with a stud. Press the plastic
anchors (A) into the holes and gently tap with a hammer until the ange of the anchor is against the wall. Insert one
screw (B) per bracket through the bracket holes into the anchors.

3. Insert one screw (B) per bracket through the bracket holes directly into studs.

4. Place wood shelf on brackets.

B

A

Directly into stud

9158148/9180464/9180472/9180480/9180241/9180290/9180373 - 12/08

page 1 of 1