! Tools required:
! Do not throw away packaging materials until assembly is complete.
bergen closet wide 3 drawer
assembly instructions
A
wooden dowel 8x
C
large cam lock 8x
E
small dome screw 6x
G
mounting plate ? x large screw 6x
J
B
cam screw ? 4x
D
smalll screw ? 4x
F
small cam lock 6x
I
L
drawer handle with screws 3x
M
9181223 / 9181199 - 11/07
drawer glide 6x
felt pad 6x
Page ? of 7
bergen closet wide 3 drawer
Left
Right
bottom edge
bottom edge
3rd hole from the front
L
D
1st hole from the back
L
D
assembly instructions
1
. Attach drawer glides (L) to side panels using small screws (D) as shown. The FRONT of each drawer glide should be f astened
through the third round hole from the front of the glide. The BACK of each drawer glide should be f
glides attach to third set of pilot holes from the bottom edge. T
e
2. Using a hammer or mallet, tap in wooden dowels (A) into holes in side panels as shown.
9181223 / 9181199 - 11/07
Page 2 of 7
bergen closet wide 3 drawer
C
assembly instructions
3. Insert large cam locks (C) into holes in side panels. Make sure arrow on f ace of each cam lock is pointed in the direction of the
hole in the edge of each panel as shown.
4. Insert cam screws (B) into holes provided on top and bottom panels as shown. Tighten cam screws with a phillips screwdriver.
B
9181223 / 9181199 - 11/07
Page 3 of 7
bergen closet wide 3 drawer
assembly instructions
5. Fasten side panels to bottom panel as shown. Fit cam screws into cam locks and tighten using a phillips screwdriver.
6. Slide back panel into groove. Make sure panel slides all the way into the bottom panel groove.
7. Fasten top panel to side panels. Fit cam screws into cam locks and tighten using a phillips screwdriver.
9181223 / 9181199 - 11/07
Page 4 of 7
bergen closet wide 3 drawer
F
assembly instructions
8. Insert small cam locks (F) into each drawer side panel. Make sure arrow on f ace of each cam lock is pointed in the direction of
the hole on the edge of each panel as shown.
9. Insert cam screws (B) into drawer front panels. Tighten with phillips screwdriver.
B
1
0. Attach drawer side panels to back panels using one large screw (I) per drawer side. Slide the bottom panel into the groove.
I
9181223 / 9181199 - 11/07
Page 5 of 7
bergen closet wide 3 drawer
assembly instructions
11
. Attach drawer fronts to drawer sides. Fit cam screws into cam locks and tighten using a phillips screwdriver.
1
2. Attach drawer handles (J) to drawer fronts using the 2 screws supplied with each handle. Tighten using phillips screwdriver.
J
9181223 / 9181199 - 11/07
Page 6 of 7
bergen closet wide 3 drawer
D
G
E
assembly instructions
3. Slide drawers onto glides and fasten together with small dome screws (E) from inside the drawer into the hole in the glide.
1
Tighten with a phillips screwdriver.
4. Multiple units can be attached together as shown using small screws (D) and mounting plates (G) . If combining side-by-side
1
use felt pads (M) between units to minimize scratching.
CARE INSTRUCTIONS
Hardware may loosen over time. Periodically check that all connections are tight.
9181223 / 9181199 - 11/07
Page 7 of 7
Loading...